Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS955609
Found behind the front panel of the door of your microwave.
This part works with the following brands: GE, Hotpoint & Kenmore.
I checked out the two posts here. The one that said that the Plexiglass and Stainless Steel snapped off as one unit didn't work for me. Tried gently to pry stainless trim but it didn't want to budge and I didn't want to force it. The second advice about using a thin knife to run down behind the Plexiglass worked.There is some kind of adhesive that stays sticky that is right at the opening edge of the door so you just have to gently break through the stickiness seal. As noted, you can bend the panel out in the middle, grab it, and slide it out toward you. Take the protective coating off the front of the replacement part and slide it in, bending it slightly in the middle so that, when it is fully in, you can push it against the sticky part to hold it in place.This was real easy. The hardest part was getting the part delivered without it getting scratched. It has a protective film on the front, but nothing protects the back and the Shipping Department insists on sending it out with nothing to protect the back from the bouncing around it gets in its oversized cardboard box. (no bubble wrap, no wrapping plastic, no peanuts). The first one arrived with the back heavily scratched. The second try (I explained the problem but the second was shipped exactly the same way as the first) had only a couple of abrasions on the back so I settled for it.Customer Service is excellent but someone should tell Shipping not to send out Plexiglass sheets without protecting both sides.
Help other customers find the most helpful instructions.
Were these instructions helpful?
My wife tried cooking popcorn without the rotating glass plate in the microwave. The door of the microwave required no tools to remove. The front plexiglass and the stainless steel trim simply snap off as a unit. Then the plexiglass slides out. Reverse to reassemble.
My brand new never used microwave had the plexiglass all fogged up by no good cleaners using harsh abbrasives. The repair was quite simple but took a few minutes to figure out. You open the door and look at the end of the door. You can see the plexiglass screen edge. Slide a knife under the edge and work it up and down releasing the two face tape that holds it in place. Then using the knife to gently hold the plexiglass off of the tape simply slide it out the end. Put some two face tape on the new plexiglass in the same location, slide it in (bowing out the plexiglass while you slide the last little bit where the tape is) and once all the way in, press down to engage the tape. That is it.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.