Quick Question!

Have you ever purchased from PartSelect.com before?

953838-1-S-GE-WB27X10682        -Magnetron
953838-1-S-GE-WB27X10682        -Magnetron 953838-2-S-GE-WB27X10682        -Magnetron 953838-3-S-GE-WB27X10682        -Magnetron http://www.partselect.com/Schematics/GE/00109918i01.gif

Magnetron

PartSelect Number PS953838

This part is used to generate microwave energy/heat.

This part works with the following brands: GE, Hotpoint & Kenmore.

This part fixes the following symptoms:

  • No heat.

Compare At

$138.43

You Save

$23.07

Your Price

$115.36
Order within the next 6 hrs and your part ships today!
Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 2.4 / 5.0, 2 reviews What's this?
1-2 of 2
 

8 of 8 people found this instruction helpful

Parts Used:
  • Magnetron
Level of Difficulty: Easy
Time to do repair: 15 - 30 mins
Tools: Screw drivers
Customer: Richard from Merritt Island, FL

Both intermittent- and no-heating

First, I read the PartsSelect DIY report by Linda, Warsaw, IN. With confidence, I purchased the magnetron. Upon receipt, I took the built-in microwave out of the cabinet, set the unit on the kitchen floor, and was stopped cold by the Safety Torx nuts on the reverse of the unit. Borrowing the right wrench allowed the 20 minute start-to-finish part changeout and reinstallation of the unit in the cabinet to proceed. The old magnetron was the defective part. Discovery of the 10-year Parts-Only warranty on the less than 10-year old unit was insufficinet to guide me to take the unit in for their Labor bill to repair. New part in hand, it just was that easy - and assumed to be no less expensive.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

9 of 19 people found this instruction helpful

Parts Used:
Level of Difficulty: A Bit Difficult
Time to do repair: More than 2 hours
Tools: Screw drivers
Customer: Linda from Warsaw, IN

The microwave would no longer heat

First I ordered and replaced the diode. That did not help. Then I ordered both the magnetron and the thermostat magnetron because I didn't know what I was doing. After I replaced those, it still wouldn't heat. So I called an electrician. He noticed I had knocked a wire loose. I connected it and the microwave worked. I reconnected the old magnetron, just to test it. It didn't work. Then I put the new one back in. It's working just fine now! It took quite a while to put everything back in place because it was a built-in. But it was a lot cheaper than getting a new microwave, even with the cost of a repair man to show me I had a loose wire!

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1-2 of 2