HANDLE DOOR

PartSelect Number PS952944

This part works with the following brands: GE, Hotpoint & Kenmore.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 5.0 / 5.0, 2 reviews What's this?
1-2 of 2
 

2 of 4 people found this instruction helpful

Parts Used

  • HANDLE DOOR

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsScrew drivers

CustomerMelissa from Chester NH

Handle broke off of microwave door

The part said it was for a GE, but it worked fine on our Kenmore Elite Speedcook. Open the microwave door. Carefully insert a knife or thin screwdriver around the black casing on the door and slowly pop off the inside door cover - be careful not to go too fast as you will break the plastic pieces that hold the cover in place. Once the inside door cover is off, unscrew the old handle, there should be two screws - one on top and one on the bottom. You can use the old screws to put the new handle on unless you strip the screws trying to get them off the old handle. This happened to us. We simply found a similar screw to use in its place. Replace the inside plastic door cover by slowly popping it back in place. Make sure you go around the whole door to make sure all the little tabs snap back in.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 1 people found this instruction helpful

Parts Used

  • HANDLE DOOR

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsScrew drivers

CustomerCathy from Madison WI

Door handle broke

The door handle on our microwave had broken at the bottom. We went on line ordered a new part, the part arrived in just a matter of days. To repair we just opened the door, poped the back off and screwed in the new handle. Very easy! And we are cooking now!!!!

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-2 of 2