Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS951943
This filter cannot be cleaned. It must be replaced.
This part works with the following brands: GE, Hotpoint & Kenmore.
Check to make sure you have a filter before you order. When I went to replace the filter, there was no old filter. I contacted the builder and he stated all microwave were vented outside. The message indicating you need to change filter is programed, you can change the program so the message will not appear.
Help other customers find the most helpful instructions.
Were these instructions helpful?
there are two screws on the top near the vent. Unscrew the two and push the vent grill/cover to the left. It slides out easily. place the charcoal filter in the exhaust slot. there is no groove/slit for it as per manual, it just sits there (almost like an afterthought in design. Prop the bottom of the filter on the stubs on the lower edge of the exhaust mouth. Slide the grill/cover back and 'click' it in. put in screws. Note, since you've opened the grill/cover you might as well wipe the grease off. I used kitchen cleaner on a paper towel.
Remove two screws,slide panel to left and remove,install filter.Replace panel,and done.Service call would have cost $97,98. EH? No brainer!
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.