http://www.partselect.com/Schematics/Maytag/Maytag_Thumb/56160.gif
See part 21 in the diagram

BOARD, FLIPPER DOOR P

PartSelect Number PS901892

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.1 / 5.0, 3 reviews What's this?
1-3 of 3
 

14 of 18 people found this instruction helpful

Parts Used

  • BOARD, FLIPPER DOOR P

Level of DifficultyA Bit Difficult

Time to do repair:More than 2 hours

ToolsScrew drivers

CustomerJames from Naples FL

Maytag skybox would not dispense

First removed the two screws that hold the flapper door switch in place. Then unplugged door from main unit and removed door. Removed the door gasket. Placed door face down on table and removed about 14 screws to expose the the plug end of the switch assembly.

Plug in the new switch assembly and thread thru hole. Reinstall the door panel. Reinstall the gasket. Reinstall the switch cover. Rehang the door and plug to main unit. The machine now properly dispenses cans.

Help other customers find the most helpful instructions.

Were these instructions helpful?

6 of 8 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsScrew drivers

CustomerJoseph from Burlington WI

Machine reported a jam every time a can was dispensed

Removed fridge door by opening all the way and lifting up ( don't forgit to unplug wire harness)
Removed all screws on back side holding two faces together, replaced parts.

Help other customers find the most helpful instructions.

Were these instructions helpful?

4 of 4 people found this instruction helpful

Parts Used

  • BOARD, FLIPPER DOOR P

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsScrew drivers

CustomerMark from Mooresville NC

Maytag skybox leds flash won't dispense

Door flapper sensor malfunctions and will not dispensense more than 1 without reseting appliance by opening and closing the door. Remove 2 screws by sensor. Remove door seal. Under the door seal remove 14 screws that hold door facing on. plug new sensor cable into board and reassemble. Count on doing every 2 - 3 years. This part is destroyed by condensation so consider stocking up on it, who knows how long it will be available.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-3 of 3