Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS900236
This part ignites the gas within the dryer. Be sure to not handle this igniter by the gray part as it is very fragile.
This part works with the following brands: Frigidaire, Gibson, Kelvinator, Kenmore, Tappan & White-Westinghouse.
This part fixes the following symptoms:
Pulled unit out from wall to access back panel. Top needs to be removed to get to the screws that hold on the front panel and door. These need to be removed to get to the valve and burner. Once your in, the sensor, thermostat, and igniter are right up front. Sensor and thermostat were easy, the igniter breaks very easily...how do I know? Cause I broke the one I bought and had to get a new one.I also replaced the coil set for the gas valve, because I had read that they can go bad and cause a gas fume smell. The coils are cheap, so you may as well as do them at the same time.Anyway, once the repair was complete, I reassembled the unit and hooked up the vent.Runs like new, and the clothes dry quickly.
Help other customers find the most helpful instructions.
Were these instructions helpful?
First of all, let me thank your wonder web site and service. Here is the step-by-step procedure:Unplugged the power.Accessed the heater assembly from the front left lower corner. Turned off the small gas valve. Unscrewed the copper nut connecting the small gas valve and the heater assembly.Disconnected the 3 wire connectors.Unscrewed 2 screws under the heater assembly.Took out the heater assembly.Unscrewed the screw for the igniter assembly.Installed the new igniter assembly. Be very careful with the M shaped coil. I broke a new one. That is why I have order the same part twice. But it still cost me less for hiring a tech or buying a new dryer.Carefully put the heater assembly back into it position.Connected the gas connector.Secured the heater assembly to the bottom of the dryer with 2 screws.Connected 3 wire connectors.Turned on the small gas valve.Plugged in and ran a test.It worked!!.
because the parts were not to bad in price i canged the egnighter the coils and the thermostate, I changed the sensor and that was not the problem so after i purchest the parts mentioned above it fixed the problemi first removed the 2 phillips screws holding the egnighter and removed the old egnighter two phillips screws and installed the new one and i removed the two philips screws holding the plate on the coils and removed the wires and installed the new coils, to the right the thermostate in the fan assembley removed tthe two phillps screws removed the wires and installed the new one reassemble the dryer and good to go I couldent beleve how fast the parts came in like the next day Thank you Parts select
The appliance is gas, which made me a little nervous. However, knowing that I had the gas off, I carefully began disassembly. The burner unit is a very simple set up and within a few minutes I had the entire assembly out and noticed that in fact the igniter was broken. I ordered a new one from partselect.com and it was delivered in 2 days! The worst part of the assembly was when I accidentally bumped the new igniter against the underside of the dryer and broke the brand new one!!!..So, I ordered a second igniter and 2 days later installed it in about 30 minutes.
Raise the top and remove the front panel assembly. One philips screw, 24mm gas line coupler and 3 electrical connectors frees the burner assembly. Slid the old igniter out and the new one in.2 philips screws to remove the coil retainer and replace the coils.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.