Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS8746671
This part comes with the heat shield and the tower. It is located on the lower half of your dishwasher. Water is forced through this spray arm by the unit's pump and motor assembly. The force of the water propels the spray arms, spraying water and detergent onto the dishes on the dish rack.
This part works with the following brands: Frigidaire, Gibson, Kelvinator, Kenmore, Tappan & White-Westinghouse.
This part fixes the following symptoms:
Over Thanksgiving, the spray arm in my dishwasher apparently popped off and was partially melted. I remounted it inside the dishwasher, but the new hole was on the side of the arm. I think this resulted in water being sprayed directly against the door and not up through the top holes. It flooded my kitchen floor.The spray arm pops on and off with plastic tabs (?) at the base. You can lightly pry with a butter knife or simply wiggle it off. The new one popped right on. Easiest repair EVER.
Help other customers find the most helpful instructions.
Were these instructions helpful?
Removed old arm from elment. then replaced with new one.
Only took me 5 sec, just push it in. Good as new. Thanks for the fast deliver .
took it out of the bag and snapped it in. Less than 10 seconds.
Pulled the broken one off, snapped the new one on.
Remove old spray arm and pressed the new part into place. Let the dishwasher run and the load came out very clean. Overall very pleased.
Found your website, red the reviews, followed the simple instructions provided by others that had had the same problem and repair was complete in less than a minute. No tools needed. I am a handy girl and tackle a lot of repairs/projects, this is the first time that the job was actually easier than stated. Thanks for providing a good porduct, at a decent price WITH LAYMAN INSTRUCTIONS!!!
I just popped on a new Arm. So easy. The amazing thing was how fast I had the part and how easy it was to find on Partselect.com. I ordered the part Monday and had it Tuesday. I was stunned and the tenant was impressed.
pulled the old part off (no tools required) and snappen on new spray arm
I used a screwdriver to remove melted spray arm. Then snapped the new spray arm into place. It was an easy repair thanks to the correct part from PartSelect.
Take out the old arm, and snap in the new one.
I snapped the new one into place and ran the cycle. This time, everything came out clean, except for the bowl that had caked on cinnamon from the weeks I didn't have the part
open dishwasher, pull out bottom rack, unscrew nut, install nut into sprayer arm, then with a clockwise motion screw sprayer arm with nut on to receiver until sprayer arm spins And nut is tightened. also i would like to thank PARTS SELECT FOR THE SPEEDY DELIVERY. THANK YOU
Snapped the new one on
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.