Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS8746144
This is an ice and water filter. The most common reason you would need to change this part is if you have never updated your model and it is no longer filtering your water. This also may lead to your refrigerator not dispensing water or ice properly. Manufacturers recommend you change your filter every six months to ensure it properly filters impurities. This will also ensure a normal dispensing rate. Note: As per the manufacturer, this is an updated water filter. If you have never installed the updated part or your old model was made by Culligan, you may need the adapter to install the filter. See Related Parts. Sold individually.
This part works with the following brands: GE, Hotpoint & Kenmore.
This part fixes the following symptoms:
I watched the video, and noticed that they did not even turn off the water. The replacement took less than 30 seconds once the filter was filled with water.
Help other customers find the most helpful instructions.
Were these instructions helpful?
with my hands
I am very handy and figured it out by myself. I installed the water valve - bracket assembly and control board within an hour and the dispenser works fine. I recommend that you all make installation links on line more user friendly. Thanks.J M Joly, MD
Unscew top screw, remove seal from inside door, remove bottom handle screw, replace w/ new handle, replace seal.
simply read the instructions
it was easy. Open the fridge,untwist the old filter. Open the new filter, fill with tap water and twist in place. Run water through it for a few minutes to insure it is working and filters the water.
I removed sheet metal covering coils, held in place with 4 screws. I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires. Replaced bad heater element with new one in reverse order.
Removed the exterior 4 screws and 1 holding the metal rod underneath. Sepearated the plastic parts pulled out the dispensing mechanisim. Removed the lock washer, then removed the spacers and blades. Put the new blades in with the spacers and reversed the other steps and done.
replaced the filter with the new one i purchased
easy easy easy!!!!!
Simply twisted off the old water filter, unwrapped the new one and twisted it on.
Pop off the control board for the ice selector/water. Remove power / signal connections. remove four phillips screws, Remove plastic hopper. Pop off Ice door gasket, pop in new one and put back together. If you fridge was sounding like it was speeding up and slowing down, this will correct this problem as well.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.