Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS869316
This icemaker can be used with 25-27 cubic feet refrigerators that have a vertical auger dispenser located on the freezer door. Reuse bottom bracket from the original icemaker and attach to the new.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
This part fixes the following symptoms:
This model uses light sensors to control the icemaker. After determining that the light and sensors operate correctly, the problem is either the icemaker module or the valve. After 6 years there was visible corrosion on the blades, so I selected the entire assembly for about $40 more. The new unt fit perfectly. Wait a while 2-4 hours to see if it works, it is not right away.
Help other customers find the most helpful instructions.
Were these instructions helpful?
Easily remove and replaced with new one. Do this yourself if you have ice maker problem don't call for service.
The replacement was an almost exact match, except for the plastic sidewall that needed a hole in it for the water supply shoot. Just removed a couple screws, and reattached the old one. A wire harness and three screws later, and we were making ice.
First tested the water control valve on back to make sure water was getting to the ice maker. Then, replaced ice maker. Old Ice maker was easy to remove and new one was just as easy to install. Simply slide out the ice maker diconnect at the wire connector, connect new ice maker and slide back in. Turn on ice maker and began producing ice.
First I cut the icemaker off. Then I removed the screw to the wire cover,next the two screws to the icemaker door, pushed in the retainer clips on the bottom of unit, pulled the unit forward, disconnected the wire harness.Remove the bottom of old unit, attach it to new unit . Plug in the wire harness , push the unit in re-assemble wire cover, ice maker door. Turn ice maker on.Less then 2 min. it filled with water. Droped ice about 1 hr. later. That was sweet music to my ears.Has been making ice every day. I'm glad I orderd the icemaker from Part Select, I waited 5 months for a repairman to get back to repair the unit. Wasnt that difficult to replace. Peace of cake.
Disconnected power supply and removed back screw which released ice maker from freezer. Removed bottom plate from old ice maker held in place by three additional screws, attached to new ice maker and re-installed. Very simple replacement and I would order again from PartSelect.
removed old unit, and replaced with new one found the job to be very simple. I hand no problems.and the unit is working fine.
I ordered a new ice maker because at least a couple of the parts on my old one were broken. I also ordered the valve because I wasn't sure that wasn't also the problem (turns out it was still functional). I removed the ice maker cover, one screw that held a shroud over the water inlet, another screw that held the ice maker to the inside of the freezer, disconnected the wire harness, and slid the ice maker out. I reversed the procedure to install the new one. It was a real breeze! I have returned the valve to Partselect and have been making ice ever since. SO much easier than buying bags of ice all the time!
removed front door. removed one screw on wireharness cover. slid icemaker out. disconnected wireharness. removed bottom 3 remaining screws. reversed process to reinstall.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2016 , Eldis Group Partnership. All rights reserved.