http://www.partselect.com/Schematics/Frigidaire/Frigidaire_Thumb/4R22EALJ.gif
See part F30 in the diagram

STARTER KIT

PartSelect Number PS8689661

This part works with the following brands: Frigidaire, Gibson, Kelvinator, Kenmore, Tappan & White-Westinghouse.

This part fixes the following symptoms:

  • Will not start.
  • Compare At

    $59.04
  • You Save

    $9.84
  • Your Price

    $49.20
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.2 / 5.0, 3 reviews What's this?
1-3 of 3
 

24 of 38 people found this instruction helpful

Parts Used

  • STARTER KIT

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsNutdriver

Customerron from hawthorne CA

Freezer and fridge stopped cooling. Could hear compressor clicking on, smelled electronics overheating, starter melted.

remove the rear cover, and simply pull off harness and replace starter.

Help other customers find the most helpful instructions.

Were these instructions helpful?

20 of 27 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsNutdriver, Pliers

CustomerJAMES from LA MESA CA

Extreme noise for 3 months, then not cold

Pulled the fridge from encloser, removed rear cardboard cover and found compressor in rear. The compressor, being very accessable, was easy to find the bad starter/capacitor. I removed the spring retainer, pulled the capacitor off the starter, removed the starter by pulling outward and replaced with new. All went well when the unit started and cooled as new. Some noise at times, but traced to icemaker. As time went by, that noise was gone.

Help other customers find the most helpful instructions.

Were these instructions helpful?

10 of 17 people found this instruction helpful

Parts Used

  • STARTER KIT

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsPliers, Screw drivers

CustomerMichael from Ayden NC

Starter smoking when first coming on

The retaining wire keeping the starter in place was first removed then the starter was easily removed. Pulling the old wire off was a little difficult because I had to pull harder than I expected. Getting the wire back on was probably the hardest part. I had to compress one part of the plug so I could get it to fit back on then it was simply a matter of placing the starter back in position and replacing the wire that holds it snugly in place. 20 minutes or so start to finish and new starter works well.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-3 of 3