18 of 30 people found this instruction helpful
Level of Difficulty: Really Easy
Time to do repair: 15 - 30 mins
Tools: Nutdriver, Screw drivers
Customer: Warren from Stillwater, MN
Top and bottom rack were rusted thru
Bottom rack - slide the old one out, slide the new one in. The rack came came with the wheels, so I didn't use the replacement ones.
Top rack - remove the rail end caps - they will likely break so order new ones. Slide the rack out. Remove the rotating spray arm and then remove all the brackets. I was able to re-use the old brackets and didn't need the replacements. Install the old brackets on the new rack, install the spray arm, and slide the new rack back into the rails. The new top rack also came with wheels installed, so I didn't use the replacement ones. Once the rack is back in the rails, install new rail end caps. Put them in sideways and facing into the washer. Straighten the caps and turn them into place. Be careful with the rail caps - they break easy and are expensive. Make sure they hold the top rack in place, and that's it.
7 of 18 people found this instruction helpful
Level of Difficulty: Easy
Time to do repair: Less than 15 mins
Customer: Joel from Temple, TX
The spray arm was off and without brackets
I looked at the diagram on the web site, the same one that I ordered from, and figured out how all the parts were suppose to go together. The spray arm has 2 brackets so it was a matter of aligning the tube that feeds the spray arm with the supply line on the back of he dishwasher. I had to move it once to get it properly aligned but found it to be simple.