http://www.partselect.com/Schematics/Frigidaire/Frigidaire_Thumb/FR1LXKHX.gif
See part F3 in the diagram

Tub Gasket

PartSelect Number PS8260227

The gasket provides a waterproof seal between the tub and the door.

This part works with the following brands: Frigidaire, Gibson, Kelvinator, Kenmore, Tappan & White-Westinghouse.

This part fixes the following symptoms:

  • Leaking water.
  • Compare At

    $12.82
  • You Save

    $2.14
  • Your Price

    $10.68
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Videos For installing this part.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.4 / 5.0, 29 reviews What's this?
16-29 of 29
 

1 of 1 people found this instruction helpful

Parts Used

  • Tub Gasket

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

CustomerLarry from Signal Mountain TN

Leaking dishwasher door

For some strange reason my new dishwasher was installed without a door gasket, which caused a very small water leak. The gasket I purchased was installed in less than 5 minutes and corrected the problem immediately - a very easy task and I am no handyman!

Help other customers find the most helpful instructions.

Were these instructions helpful?

2 of 5 people found this instruction helpful

Parts Used

Level of DifficultyA Bit Difficult

Time to do repair:1- 2 hours

ToolsScrew drivers

CustomerRonald from Chardon OH

Small leak under door

The main tub gasket just pulled out by hand - no tools needed. Installing new one was just as easy, Just remember the wide part of the gasket sits in the bottom of the groove and cut off the excess with scissors.
Door gasket - not so easy. The six screws near the top of the door do NOT need to be removed, only the two (phillips) mid-way down the side. Remove the bottom panel by pulling down (it sits in a pocket of the top panel). The bottom door gasket just pulls out and insert the new one by hand (can be tight). Re-install bottom panel by sliding up into the top panel pocket, aligning the holes and screw home.
Normally,, you would be done but not in my case. The slow drip was still there. Investigation revealed that under the bottom panel (yes, we took it off again) is a tie-wrap holding wires at the bottom of the door that collects condensed steam and allows it to drip outside of the bottom plastic tray onto the floor. We thought that the tie-wrap was unnessesary and cut it off. Test drive- No more drips!

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 3 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

CustomerJames from Sioux Falls SD

Dishwasher was leaking in a house we just purchased.

pulled the old gaskets out, put the new ones in. Just like that. No tools, nothing. I would compare it in difficulty to the process of paying for gas at the pump and then filling your car up.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 3 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:30 - 60 mins

ToolsPliers, Screw drivers

CustomerMark from West Linn OR

Installed springs, linkage, gasket, and bracket

Repair was easy. Unfortunately I really didn't need the springs or linkage, but I couldn't see that until I took the dishwasher out from the counter. The springs were not stiff enough to keep the door from just falling open. So I cut about an inch off the long end and bent it into a hook. I didn't need new linkages the old ones were fine. The gasket made the biggest difference and went in very easy. The door will be difficult to close for a few times then everything works great.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 3 people found this instruction helpful

Parts Used

  • Tub Gasket

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

CustomerBob from Clinton OH

Leaking tub seal

Just pulled the old gasket out and popped in the new. I did trim it too shrt however so be careful not to do that.

Help other customers find the most helpful instructions.

Were these instructions helpful?

0 of 1 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsScrew drivers

CustomerROBERT from RANCOCAS NJ

Latch was broken

Unscrewed the front. Took out 2 screws on the old latch and put in the new one. Fast and easy.

Help other customers find the most helpful instructions.

Were these instructions helpful?

0 of 1 people found this instruction helpful

Parts Used

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsNutdriver, Screw drivers

CustomerDon from Sedalia MO

Cleaned the inside bottom of dishwasher, leaked after I cleaned it.

After watching a wash cycle with the front cover off, I noticed water coming out from the bottom of the pan, under the Gasket. Pulled the gasket down out of the slit and reinstalled the new one exactly as the old one came off, with the wiper angled the correct direction.

Help other customers find the most helpful instructions.

Were these instructions helpful?

0 of 1 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsScrew drivers

Customerthomas from Milford PA

Leak from door bottom

I want to praise your company for getting the part to me quickly and the parts being right. I have found this most difficult for many online companies. Thank You Tom Z

Help other customers find the most helpful instructions.

Were these instructions helpful?

0 of 1 people found this instruction helpful

Parts Used

  • Tub Gasket

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

CustomerJames from Franklinville NJ

Water leaking around the edge of dishwasher

Orderd new gasket which arrived extremely fast, old gasket just pulls out , installed new one same direction as the old gasket fit, stopped leak. Thanks!

Help other customers find the most helpful instructions.

Were these instructions helpful?

0 of 1 people found this instruction helpful

Parts Used

  • Tub Gasket

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

CustomerAllan from Portland OR

Dishwasher was leaking

Had a leak, due to the factory gasket was 1/2 " to short. Pulled out old one, installed new one, and trimed to fit. Took less the 5 minutes.

Help other customers find the most helpful instructions.

Were these instructions helpful?

0 of 1 people found this instruction helpful

Parts Used

  • Tub Gasket

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

Customerjimmy from canon GA

Water leak around bottom of door

removed old gasket by hand, installed new gasket with hands only. p.s. great doing business with you,thanks.

Help other customers find the most helpful instructions.

Were these instructions helpful?

0 of 2 people found this instruction helpful

Parts Used

  • Tub Gasket

Level of DifficultyEasy

Time to do repair:Less than 15 mins

ToolsPliers

CustomerClarence from Gerald MO

Dishwasher leaked around the door

My Son used needle nose pliers to remover the old gasket, then starting on the lower right side, inserted the new gasket and used the rounded end of handle of a wooden spoon and pressed the gaste in place by running the handle up and around the top then down the left side. Used sissors to cut the new gasket to length. Door fit very tight. Ran a normal wash cycle and no leaks.

Help other customers find the most helpful instructions.

Were these instructions helpful?

0 of 2 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

Tools

CustomerRonald from Soperton GA

Leak at bottom of door

Removed door gasket then replaced bottom gasket

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 5 people found this instruction helpful

Parts Used

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsPliers, Screw drivers

Customerjoseph from peach bottom PA

Water leaking from door

first open door and removed 8 philips screws, removed inside panel and changed lower door gasket.then reassembled in reverse order of removal.second used plyers removed tub gasket matched up to new gasket and cut to length to match old gasket.clean track on tub and install same way old gasket was in, make sure gasket is seated evenly.clean up and run dishwasher check for leaks.

Help other customers find the most helpful instructions.

Were these instructions helpful?

16-29 of 29