753786-1-S-GE-WB27T10416        -Electronic Clock Oven Control
753786-1-S-GE-WB27T10416        -Electronic Clock Oven Control 753786-2-S-GE-WB27T10416        -Electronic Clock Oven Control 753786-3-S-GE-WB27T10416        -Electronic Clock Oven Control

Electronic Clock Oven Control

PartSelect Number PS753786

Note: Wiring could differ from original, will possibly need to be installed by an appliance repairperson.

This part works with the following brands: GE, Hotpoint & Kenmore.

  • Compare At

  • You Save

  • Your Price

In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.2 / 5.0, 2 reviews What's this?
1-2 of 2

23 of 29 people found this instruction helpful

Parts Used

Level of DifficultyEasy

Time to do repair:Less than 15 mins



Buttons stopped working on the keypad.

Everybody said the Electronic clock oven control needed to be replaced, not the keypad. It was the keypad. Unpluged the range. Pulled the 4 burner control knobs off, Unscrewed the 4 burner contol knob bottoms to remove the panel cover, removed 2 of the keypad screws an loosened the other 2. Removed 4 screws holding the oven control panel. Turned the panel over to access the keypad wiring ribbon. Released the ribbon, turned the panel over to remove the old keypad. Put the new keypad ribbon through the panel and pushed the ribbon into the ribbon slot, put the anel beck in place with 4 screws, slipped the keypad in place on 2 loosened screws. put the remaining 2 screws back in. tightened all four screws. replace the control panel cover and knobs. Plug back in and viola.

Help other customers find the most helpful instructions.

Were these instructions helpful?

3 of 4 people found this instruction helpful

Parts Used

  • Electronic Clock Oven Control

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsSocket set

CustomerEric from Hemphill TX

Oven would intermittently loose all power when hot

First found and threw appropriate breakers. Then removed knobs and faceplate retainer nuts and pulled off faceplate. Next removed four control panel retaining screws and lifted out and partially spun/inverted control panel. Couldn't fully remove due to wiring. Next removed four oven control screws and pulled back control module. Then just removed all wiring connections to old control module. Worked in reverse with new control module, turned breaker back on, and just had to set the clock. Back in business!

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-2 of 2