Part Location Diagram of WB01X10192 GE CUSHION
See part 9 in the diagram
Customer Service Representative

Get in touch, we're here to help!

Daily 8am - 9pm EST

customerservice@partselect.com

CUSHION WB01X10192

Rated by 1 customer 

A Bit Difficult 

30 - 60 mins 

Ratings submitted by customers like you who bought this part.

$ 7.68
  Special Order
Get FREE EconoShip on orders over $100! T&C apply
PartSelect Number PS751882
Manufacturer Part Number WB01X10192
Manufactured by GE
Troubleshooting
This part works with the following products:
Microwave.
This part works with the following products:
General Electric.
Part# WB01X10192 replaces these:
WB1X10192
Back to Top
Customer Repair Stories
 Average Repair Rating: 2.8 / 5.0, 1 reviews. What's this?
Sort by:
  • 1
Sorry, we couldn't find any existing installation instruction that matched.
Cracked glass, light always stays on
Problem 1: cracked outer glass
1. Remove the outer glass assembly using the four screws along the top and lifting out/up, be very careful it doesn't fall off and break on the floor. Hold the handle while removing the last screw, it can fall easily.
2. Remove the handle using the 2 long screws on the back side which feed through 2 small metal plates that were previously holding the door onto the main cavity.
(3) If there is broken glass, it helps to remove the metal ledge the glass was on using the screws underneath and clean out all broken glass fragments, to do this you may have to remove the vent panel below it to get screwdriver access.
4. Assembling the new glass panel is the same steps backwards, should be obvious.

Problem 2: Light always stays on
1. Remove the door switch panel on the left side of the microwave, 1 screw.
2. Remove the right access panel on the right side of the microwave, this is large and has many screws, and a couple also need to be removed on top.
** Don't touch any wires when doing all this, and make sure you are grounded and don't produce an electrostatic shock. **
3. Manually toggle the door latch catchers on either side (just the plastic, don't touch any wires), at the same time, and see if the light turns off. If it does, the door latches might not be putting enough pressure, they may be cracked or need to be replaced.
4. Sometimes the switches get dislodged, for example if someone slammed the microwave shut. Try nudging the switch, or one of the connectors, slightly towards the door side, or tapping it from behind with a screwdriver. If it was loose you might get an audible click when it goes back into place.

Note: if the microwave light always stays on, it eventually might shut off after a long time. Power cycle the microwave before doing the tests above, so the light is on when you toggle the door latch switches.
Other Parts Used:
Exterior Door Glass DOOR GLASS MOUNT - BLACK CUSHION PANEL-CONTROL MOUNTING WASHER - TEFLON
  • Richard from Arroyo grande, CA
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Screw drivers
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
  • 1
Questions and Answers

Be the first to ask our experts a question about this part!

Model Cross Reference
This part works with the following models:
PartSelect Number: PS751882
Manufacturer Part Number: WB01X10192
Brand
Model Number
Description
General Electric
ZSC2000CBB02
Microwave - Counter Top
General Electric
ZSC2000CWW02
Microwave - Counter Top
General Electric
ZSC2000FBB01
Microwave - Counter Top
General Electric
ZSC2000FBB02
Microwave - Counter Top
General Electric
ZSC2000FWW01
Microwave - Counter Top
General Electric
ZSC2000FWW02
Microwave - Counter Top
General Electric
ZSC2001CSS02
Microwave - Counter Top
General Electric
ZSC2001FSS01
Microwave - Counter Top
General Electric
ZSC2001FSS02
Microwave - Counter Top
Customer Service Representative

Get in touch, we're here to help!

Daily 8am - 9pm EST

Contact Customer Service