3 of 5 people found this instruction helpful
Level of DifficultyReally easy
Time to do repair:15 - 30 mins
ToolsNutdriver, Wrench set
CustomerRobert from Mullica Hill NJ
Conversion back to natural gas from propane
I converted the cooktop from propane to natural gas, the parts I was told I needed were the incorrect parts. I called because I was not sure about the listed parts. I was helped over the phone but recieved the LP parts. The flame was very low, and i found the orifices I replaced were the same parts I just took out.I contacted Parts select and they were helpful and credited my purchase without any hestitation.Once the new orfices were recieved it was easy to install. I recommend using a nut driver with sticky tape to go the orifice holder after the venture is removed. You do not have to disassembe the stove as long as you don't drop the part. Changing the regulalor was also very easy by removing the gold nut and pulling the white pin out and flipping it over to Nat. The flat side of the pin is labeled LP or NAT. Then just screw the nut back in and tighten. The LP orifices are labeled on the side 0.65, 0.69, and 0.70 the natural gas orifces are colored black, silver , and red. It would be just as easy to go from Natural gas to LP!