724852-1-S-Frigidaire-134146100         -O-Ring/Gasket
724852-1-S-Frigidaire-134146100         -O-Ring/Gasket 724852-2-S-Frigidaire-134146100         -O-Ring/Gasket

O-Ring/Gasket

PartSelect Number PS724852

This part is between the front and rear outer tubs.

This part works with the following brands: Frigidaire, Gibson, Kelvinator, Kenmore, Tappan & White-Westinghouse.

This part fixes the following symptoms:

  • Leaking.
  • Noisy.
  • Compare At

    $34.80
  • You Save

    $5.80
  • Your Price

    $29.00
In Stock
Order within the next 11 hrs and your part ships today!
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 1.8 / 5.0, 2 reviews What's this?
1-2 of 2
 

21 of 28 people found this instruction helpful

Parts Used

Level of DifficultyDifficult

Time to do repair:More than 2 hours

ToolsPliers, Screw drivers, Socket set, Wrench set

CustomerTimothy from Biglerville PA

Spider was corroded and broke from being weakened by the corrosion

Removed the entire front cover of the washing machine and dicoonected the springs that support the tub. Left the tub down and disconnected the struts and unhooked all the wiring and pulled complete tub out of machine. Removed all the bolts around the tub shell and split the tub shell. Remover the motor from the sheel to make it lighter to work on, removed the pulley on the drum shaft and pulled the drum out of the shell. Found that the cast alluminum spider was weakened by corrosion and this caused the spider to break. The spider itself should be able to be purchased seperately because the stainless steel drum was okay and could have been reused. The biggets problem I had was getting the tub back in the washing machine and getting it suspended by the springs again. I used a 6 x6 block and a 2 x 6 board to lift the tub up in the air to get the tub springs hooked back up. This took 2 people to accomplished. After the tub was suspended on the springs the rest was easy.

Help other customers find the most helpful instructions.

Were these instructions helpful?

11 of 16 people found this instruction helpful

Parts Used

  • O-Ring/Gasket

Level of DifficultyA Bit Difficult

Time to do repair:More than 2 hours

ToolsNutdriver, Pliers, Screw drivers, Socket set, Wrench(Adjustable)

CustomerEd from International Falls MN

Stainless tub in front loader broke 2 out of 3 spider arms

Removed entire tub assembly, replaced bearings and seal in rear outer tub assembly, had spider arms welded by aluminum welder. alot of work ,saved 150.00 on parts by replacing bearings, savings untold hundreds by doing it myself instead of replare man.. BIG JOB. But just plug away and it goes rather smoothly.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-2 of 2