Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
★★★★★
★★★★★
Paul H - October 13, 2019
Verified Purchase
Correct part, obvious install
The screw clips for the top anchor spot are loose fitting; one came off during install & fell deep into void space of microwave. I had to fabricate my own replacement clip.
Would have been nice if you provided extra clips as they are not anchored tightly on plastic flange.
★★★★★
★★★★★
Mark B - October 6, 2018
Verified Purchase
Replacement part instalation
The part was delivered quickly as promised. It is installed and working well. I would recommend your service to others.
< Prev
1
Next >
Customer Repair Stories
Average Repair Rating: 3.0 / 5.0, 2 reviews.
What's this?
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Operable Top Room Vent and Housing on 2009 GE Microwave
The original piece which contains the operable interior vent flap and the housing which holds that vent randomly fell off the front of the microwave one evening. Apparently, all of the tabs where the connecting clips and screws had finally perished and broke off. I found the exact replacement part at PartSelect. Since the old piece was al
... Read moreready missing all I needed to do was finish removing the two screws which are at the top of the unit still holding in the original top clips. The bottom plastic snap in parts had sheared off and either fell out or I was able to pull them out with pliers. That cleared the way to install the new piece after some basic cleaning of some years of grease. I ended up taking the vent flap off (two springs and a couple of screws) so that I could see better to maneuver the housing into place. I pushed the bottom tabs in which go is straight with a slight shift to the right to engage the tabs into the metal housing of the microwave. I then put back the top screws and reconnected the front flap, again a couple screws and two springs. I did need to adjust the hinge pins by slightly bending the metal tabs just to tighten up the grip on the flap. After that it worked perfectly. It took about an hour to do as I was overly cautious.
Read less
barry from COLLEGE PARK, MD
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Screw drivers
2 of 2 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The Grille Assembly was broken on one side so it fell down a bite.
Ordered the part, and had my husband install it. We took the door off to install the grille assembly & the door has a plastic tab at the top where the door fits into the hinges on the microwave and that made it a bite harder to refit in place. But he did it without too much difficulty..
Audrey from INTL FALLS, MN
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers
1 personfound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
< Prev
1
Next >
Questions and Answers
Be the first to ask our experts a question about this part!
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.