Quick Question!

Have you ever purchased from PartSelect.com before?

473322-1-S-Frigidaire-5308001614        -SWITCH-DOOR
473322-1-S-Frigidaire-5308001614        -SWITCH-DOOR                                                                                                                                           473322-2-S-Frigidaire-5308001614        -SWITCH-DOOR                                                                                                                                           473322-3-S-Frigidaire-5308001614        -SWITCH-DOOR                                                                                                                                           http://www.partselect.com/Schematics/Frigidaire/LY5PWTEU.gif

SWITCH-DOOR

PartSelect Number PS473322

This part works with the following brands: Frigidaire, Gibson, Kelvinator, Kenmore, Tappan & White-Westinghouse.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.2 / 5.0, 4 reviews What's this?
1-4 of 4
 

11 of 13 people found this instruction helpful

Parts Used:
Level of Difficulty: Really Easy
Time to do repair: Less than 15 mins
Tools: Screw drivers
Customer: Michael from Laredo, TX

Switch went out, dryer wouldn't start

Used screw driver to pop out old switch, detached wires, attached new switch to wires and popped switch back in to positionl. Done.

Help other customers find the most helpful instructions.

Were these instructions helpful?

11 of 16 people found this instruction helpful

Parts Used:
Level of Difficulty: A Bit Difficult
Time to do repair: More than 2 hours
Tools: Screw drivers
Customer: Edward from Baltimore, MD

Drying too slowly

Removed access plate from back bottom left
Removed belt from motor
Needed to lift up top of dryer
Inserted flathead screwdirver in front under top to push in two metal clips holding top down
Lifted up top of dryer
Removed 2 screws holding on front of dryer
Removed front of dryer
Broke Door Switch removing front of dryer. I should have depressed the metal sides in and pulled switch through hole.
Instead, I tried to remove the leads. This broke the fragile prongs.
Started dryer (with belt removed so drum doesn't spin)
Verified ignightor came on every heating cycle
Gas turned on properly
Gas turned off after 90 seconds
Gas never came back on
Indicitive of bad coils
New coils solved the problem
Replaced door switch and lint trap cover in the process.

Help other customers find the most helpful instructions.

Were these instructions helpful?

5 of 5 people found this instruction helpful

Parts Used:
  • SWITCH-DOOR
Level of Difficulty: Easy
Time to do repair: 15 - 30 mins
Tools: Screw drivers
Customer: Gary from Arlington Heights, IL

Knowing how to open the top

I unpluged the machine. Pried out the old switch with the tip of a screw driver. Pried off the connectors, there was not enough extra wire for me to connect the new switch through the front of the machine. I pushed the new switch in place. Using the screw driver I carefully pried open the top front of the machine { there were 2 plastic spring clips securing the top}. I placed a wash bucket on the drum to hold the top open , connected the 2 connectors to the switch and snapped top back in place.

Help other customers find the most helpful instructions.

Were these instructions helpful?

4 of 6 people found this instruction helpful

Parts Used:
Level of Difficulty: Really Easy
Time to do repair: Less than 15 mins
Tools: Screw drivers
Customer: James from Los Angeles, CA

Dryer ran for about 5 minutes and then shut off completely, washer still worked (stackable unit)

simple fixes, knob broke required a good tug with rocking motion , put on new knob with a push.
dryer switch required a screw dryer to pop out , 2 wires on back required a tug on each to remove from lug ( blade) and a push to place back on new switch,
That was about it.s

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-4 of 4