| |
2 of 3 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:15 - 30 mins
ToolsNutdriver, Pliers
CustomerScott from Sheboygan WI
Had water constantly leaking to ice maker and freezing up also water constantly dripping at water dispenser
I started by shutting off water supply and unplugged refrigerator. Then using a nutdriver removed back lower panel exposing the dual inlet water valve on the left side which was held in place with one bolt. After unbolting the valve you can pull the entire assembly out enough to remove the three water connections. The instructions suggest cutting of about 1/2" off of the two discharge lines to provide a better connection to the new valve. The entire process was very simple. The price of the part was a small fraction of the new refrigerator my wife was threatening to buy if I did not get her ice maker working again. Thanks for another great repair experience!
|
1 of 2 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
Tools
CustomerBruce from Tucson AZ
Cracked and stained parts
Discarded/recycled old part and snapped in the new. Done.
|
1 of 2 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
Tools
CustomerMike from Rock Island IL
Existing tray broke, repalced with new tray
Removed old tray by hand, replace with new tray by hand. This web site was BY FAR the easiest to navigate to find the right part. Shipping was extremely fast, received the part the very next day without special shipping. THANKS for the "EASY" button.
|
1 of 4 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsScrew drivers
CustomerJudy from Omaha NE
My son broke the slide track on the inside door
Took the drawer out, unscrewed 2 screws to remove the broken part. Compared it to the so easy to read diagrams provided on your website and ordered the replacement. It arrived, screwed it in place! This then prompted me to clean out the frig from top to bottom! And it needed to be cleaned! The ice maker drip tray was take out the old one, slip in the new one! Very easy.
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsScrew drivers
CustomerHarold from Weatherly PA
Broken part
removed broken support and replaced it .
|
0 of 2 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:15 - 30 mins
Tools
CustomerKenneth from Loganville GA
Cracked & broken rail slides
pulled drawer front off and install on new drawers very easy
|