446564-1-M-Frigidaire-3204451-Pump-Slinger.jpg
446564-1-S-Frigidaire-3204451-Pump-Slinger.jpg 446564-2-S-Frigidaire-3204451-Pump-Slinger.jpg 446564-3-S-Frigidaire-3204451-Pump-Slinger.jpg

Pump Slinger

PartSelect Number PS446564

This part is found between the pump and the motor shield and its purpose is to make sure that nothing leaks down the shaft into the transmission. Replace if washer is leaking.

This part works with the following brands: Frigidaire, Gibson, Kelvinator, Kenmore, Tappan & White-Westinghouse.

This part fixes the following symptoms:

  • Leaking water.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 5.0 / 5.0, 1 reviews What's this?
1-1 of 1
 

34 of 41 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsPliers, Screw drivers

CustomerMichael from Woodridge IL

Washer leaking

removed front body panel (2 screws at bottom and pulled down panel), then used pliers to squeeze pinch clamps and pull back the two hoses off the pump. then removed the two pump clips that secure the pump in place and used screw driver to gently pry the old pump off the motor shaft, under that was the rubber pump slinger which was pulled off the motor shaft. The next step was to sand the rust off the motor shaft and apply some vasoline to lubricate the shaft and install the new pump slinger and pump on the motor shaft,put the pump clips back on and push the hoses on the new pump and slide the pinch clamps back into place, run test to check for leaks then re-install the front body panel.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-1 of 1