437415-2-S-Frigidaire-316035200         -Gas Spark Ignition Switch
437415-2-S-Frigidaire-316035200         -Gas Spark Ignition Switch 437415-1-S-Frigidaire-316035200         -Gas Spark Ignition Switch 437415-3-S-Frigidaire-316035200         -Gas Spark Ignition Switch

Gas Spark Ignition Switch

PartSelect Number PS437415

When the gas burner valve knob is depressed and turned, this part creates a spark that lights the gas and starts the burner

This part works with the following brands: Frigidaire, Gibson, Kelvinator, Kenmore, Tappan & White-Westinghouse.

This part fixes the following symptoms:

  • Will Not Start.
  • Compare At

    $39.05
  • You Save

    $6.51
  • Your Price

    $32.54
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.2 / 5.0, 2 reviews What's this?
1-2 of 2
 

9 of 10 people found this instruction helpful

Parts Used

  • Gas Spark Ignition Switch

Level of DifficultyEasy

Time to do repair:Less than 15 mins

ToolsScrew drivers

CustomerDonald from Middle Village NY

Two top burners would not light, defective switch

Warning- we found a lot of bare wires in this stove, check your wires before replacing the bad switches. I lifted the top, disconnected the power, pulled off the knobs, unscrewed the switch for the back light, removed seven screws to finally get the front panel off. Once you have the front panel off, changing the swich takes less than a minute. The switches just slide off the gas valve stems. Instructions show how to line up the new D-shaped switch mechanism to match the D-shaped shaft. Gently pull the two wires off the old switch and slide onto the new switch. Then put the panel back.

Help other customers find the most helpful instructions.

Were these instructions helpful?

3 of 5 people found this instruction helpful

Parts Used

  • Gas Spark Ignition Switch

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsNutdriver, Pliers, Screw drivers

CustomerLen from Corry PA

Switch plate cracked.

This hard to find GE part number was easy to find at PartSelect.com. The GE dealer said the part was permanently out of stock. Lift lid and remove a few screws and pull off two wires and replace switch plate and reconnect everything. Good to go.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-2 of 2