Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS434226
This part works with the following brands: Frigidaire, Gibson, Kelvinator, Kenmore, Tappan & White-Westinghouse.
This part fixes the following symptoms:
used a screwdriver pushed the old ones out put the new in. the video instructions were great.
Help other customers find the most helpful instructions.
Were these instructions helpful?
Pulled broken one out, slid in the new. Most unbeliveable service I have ever received. Tremndous job, you should sell it to others, Many thanks
first i took out burners then i took out the screws of the termnal block bracket. i then raised the lid on the stoveand clipped the wires on all 4 of the terminal block kits.i then slipped the shrink wrap on wires and used the wire nuts to connect wires together then heated the shrink wrap. I then put screws back in terminal block brackets. I then put the burners on while looking under lid so i would know they were making good connections as this is a bad design from factory. if you pull out burners to clean them and they are not put back in right you dont have a good connection and that causes the terminal blocks to get hot and melt. thats what happened in my case. As far as the drawer glides they just snap into place
Frst I slid the drawer out.I then pryed the broken drawer glides off with a flat blade screwdriver. The new drawer glides then just snap into place,then reinstall the drawer and check for smooth operation.
It was so easy my wife did it bu snapping in the new clips.
This was very simple I just snap the part on no tools required. it took less than 2 seconds.
Snapped the new part into the slot the old one had been in.The repair including opening and closing the drawer took less than a minute.
Used a paint spatula to pop upwards the old bottom half of the door handle trim, has metal inserts inbetween pieces.Snapped new ones on.Was initially intimidated, but only took 5 minutes to replace both.
snapped the new piece of plastic in its place and ta da, its fixed.
With the draw glide, I simply had to slide it into position. To replace the clock, I had to remove the back panel and then replace the broken clock with the new one by simply turning a few screws and using a pair pliers to removing the color coded wires.
snap out the damage one replace whith the new one
The front glides easily snap into a hole on the sides of the range. The rear glides easily snap onto the sides of the lower rear of the drawer.
just put in slot
Remove drawer. Insert new slide. Install drawer.
Used a slot screwdriver to pry the old guide...clipped the new guide into its place.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.