Door Closing Cam

With a screwdriver, remove the hinge cover-plate on the top of the door. This reveals the two nut-driven screws that hold th top hinge-plate: remove while children/wife/neighbor/butler/out-of-work-political consultant hold the door. Take out the screw on the Bearing plate and replace with new. (I replaced, but kept the old one. Like to replace parts that ride on each other in pairs, even if there is no noticable wear. Next, take the old Bearing-hinge from the bottom of the door that whomever is holding. Needle-Nose Pliers might be handy if your bearing-hinge is also shredded. Re-assemble being careful to place the bottom hinge into the Bearing without catching or scoring the Bearing hinge. Don't want to do this again in six monthes.
While I was under there with the base/bottom plate removed, I noticed the dust and crud and vaccumed after replacing the door.

Replaced the drawer cover/shelf. Took the door off & put in the new plate....simple.

Unplug refrigerator. Take out spill tray by sliding out. remove bottom 3 screws, gently but firmly push up and against refrigerator(Top section of cover snaps in by pulling cover down while holding cover against refrigerator). There is a ribbon wire connecting the two boards, care not to tear it out of connectors. There are two tabs on the plastic connector holding the ribbon wire to the outside board,pull the tabs out a little and gently pull the ribbon loose, carefully. There are 3 screws holding in the back board, remove them, them remove water hose from water actuator so the assembly can come out. Gently spread the plastic holder to be able to take the broken paddle out. Watch closely how the third arm on the actuator(Lower left arm)is resting on the back of the flapper.Replace the Actuator exactly the same. Just reverse the steps to install the rest of the parts.(Had a time getting the water hose back into it place. I used pliers to push and wiggle it back into it opening).Don't forget to plug the frig back in again. DOOR CLOSING CAM AND HINGE BEARING ARE VERY EASY. It take about 10 to 15 minutes to do. Empty door drawers before procedure the screw holding the plastic cover, remove cover. I used a 3/8" nut driver and my cordless drill to take out the two lag bolts holding the top hinge.Lift door off bottom hinge. Replace Door Closure/Hinge Bearing. Reverse procedure to finish installation.