Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS430814
Sold individually. This cam is located at the bottom of the fridge/freezer door.
This part works with the following brands: Frigidaire, Gibson, Kelvinator, Kenmore, Tappan & White-Westinghouse.
This part fixes the following symptoms:
Sold individually. Also known as a short door closing cam.
Took off bolts on top hinge , lifted the door off lower hinge With a srew driver was able to remove an replace both parts . The doors is as good as new :0)
Help other customers find the most helpful instructions.
Were these instructions helpful?
I first ordered the part as a Frigidaire and when it came in it seemed wrong. Then I realized the refrigerator was manufactured by Electrolux, so I went on their (your) site and ordered the plate which was pictured. It came in correct as I could see. I asked to return the first part to Frigidaire and they gave me credit. When I removed the door, I realized I needed both parts the plate and the door closer cam. It took very little time. I called on the Frigidaire part to have them cancel the credit card charge back but it had been done at noon that day. I offered to pay for the part but the lady said she had no way to accomplish that. I told her I was sorry that I had caused the confusion. Ordering from them as well as your organization has been very easy and a pleasant experance. Thanks.
piece of cake... removed upper hinge, old bearing hinge came right out ... Installed new piece and was done in less than 5 minutes... It took longer removing all the stuff from the door shelves,then it did to fix the problem.
With a screwdriver, remove the hinge cover-plate on the top of the door. This reveals the two nut-driven screws that hold th top hinge-plate: remove while children/wife/neighbor/butler/out-of-work-political consultant hold the door. Take out the screw on the Bearing plate and replace with new. (I replaced, but kept the old one. Like to replace parts that ride on each other in pairs, even if there is no noticable wear. Next, take the old Bearing-hinge from the bottom of the door that whomever is holding. Needle-Nose Pliers might be handy if your bearing-hinge is also shredded. Re-assemble being careful to place the bottom hinge into the Bearing without catching or scoring the Bearing hinge. Don't want to do this again in six monthes.While I was under there with the base/bottom plate removed, I noticed the dust and crud and vaccumed after replacing the door.
Replaced the drawer cover/shelf. Took the door off & put in the new plate....simple.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.