| |
2 of 4 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsScrew drivers
CustomerGraciela from san jose CA
Drawers support glide were broken and the side of the upper storage drawer was cracked
Very simple. I removed 2 screw each holding the old drawer support glide and I replaced it with the new support( 3 minutes to replace using old screws )
To replace the drawer I removed the front part of the drawer(just pop out) and I attached to the new drawer(no tools needed).
Now It looks I have a new refrigerator.
|
1 of 2 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsNutdriver, Screw drivers
CustomerDavid from Cumming GA
Drawers and support brackets broken
removed good old clear plastic drawer fronts by prying loose with a screwdriver at the bottom of drawer.and sliding out upwards. placed old fronts on new drawers by sliding downward and snaping in place. removed old support guide using a nut driver and installed new one.removed both crisper drawer cover supports prying out with a screwdriver.pushed broken post of these supports back into the refrigirator wall with a flat punch.installed new supports and pushed locking post in with my punch and hammer. installed new cover storage pan.put in new drawers top and bottom with glass.about a 20-30 minute job.
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsScrew drivers
CustomerLinda from Marlton NJ
Broken drawer side edges and supports
I was able to make the repair in very little time, took longer to empty the refrigerator and remove the broken pieces than it did to install the new ones. I originally ordered some incorrect items and was amazed at the quickness of receiving the correct pieces --- I have already recommended you to several friends and will definitely use you again should the need arise.
|