| |
5 of 7 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:1- 2 hours
ToolsPliers, Screw drivers, Wrench set, Wrench(Adjustable)
CustomerMary from Royersford PA
Had no ice water. Replaced door gasket. Broken drawer
First I turned off the water feed and remove the plug from receptacle and wires from valve. Replaced water valve and reconnected wires to valve.
Replaced inside drawer.
Remove screwes under door gasket, replaced door gasket. No need to buy a new refrigerator right now.
Your parts manuals made it easy to find parts.
|
3 of 3 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:1- 2 hours
ToolsScrew drivers
CustomerRODRIGO from UNCASVILLE CT
Excessive ice formation on cooling coils of the freezer section led me to believe that air must be finding its way into the freezer section, which led me to think that the freezer section was not adequately sealed.
Ordered gasket and gasket arrived within 48 hrs. Put the unit into out-of-commission status. Defrosted cooling coils. Dried the coils thoroughly. Reinstalled cover panel to the coils. Removed existing door gaskets. Installed new (2) gaskets. So far ice buildup to the coils had ceased.
|
2 of 3 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:30 - 60 mins
ToolsScrew drivers
CustomerBill B. from Benton TN
The gaskets on the freezer & refig.Door were cracked
Unscrewed the gaskets from the doors and took off. screwed the screws and put tthe sealant on t he cornors on both doors and that was it. very easy. directions were great.
|
1 of 1 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:30 - 60 mins
ToolsScrew drivers, Socket set
CustomerRobert from Manitowoc WI
Refrigerator magnet was bad on gasket and top hinge was broken on freezer door this was a side by side unit
the freezer hinge was very easy to replace the refrigerator gasket was removed by taking the screws out and removing the door panel new gasket was put on the door panel then screwed back on the door the gasket was not fitting against the refrigerator cabinet real good untill I heated it up with a blowdryer then it fit fine.
|
1 of 3 people found this instruction helpful
Parts Used
Level of DifficultyA Bit Difficult
Time to do repair:1- 2 hours
ToolsScrew drivers
CustomerJeffrey from Harrison AR
Gasket was partly melted from nearby dishwasher
Removed everything from the door. Removed all the screws from the door and took off the door panel. Laid panel out and fit gasket on it and then put it back on starting at the top. Used hair dryer to remove kinks from gasket from shipping. Everything went well. I left the door attached to the refigerator. There would be no way in my opinion to put the gasket on by just loosening the screws as the instructions stated. Its just too hard to get the gasket in that way. But taking the inside door panel; off worked well.
|