| |
5 of 6 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsPliers, Screw drivers
CustomerJOHN from LA QUINTA CA
Water not draining
the pump was making some loud noise so i removed the bottom cover and the drain pump is right in the front the motor was hot the washer had water on the bottom so i started the washer hit the pump with a screw driver handle to get it started drained the water and used pliers to in still. not bad at all.
|
4 of 7 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:1- 2 hours
ToolsNutdriver, Pliers, Screw drivers
CustomerTheodore from Salisbury NC
Fin in pump broke
pulled out dishwasher ,left lines hooked ,started cicle .heard pump.took apart.seen problem. order new one ,works like new..
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:30 - 60 mins
ToolsScrew drivers, Wrench set
CustomerCraig from Fairway KS
Water leak and broken latch
We knew the latch was broken, but operational if you held it just right. I disconnected the water line and electricity to slide the dishwashwer out from the cabinet. Determined that hose had been chewed through by a mouse. Ordered the parts. when they arrived, changed the hose, slid the dishwasher back into place and tested. No leaks. then removed 6 screws to remove the face, 2 more screws and the wires to remove the broken latch, reversed the processed to replace and replaced the old seal. Loaded the dishwasher and it works like new.
|