419285-1-S-Frigidaire-134051000         -Drive Belt - 6 ribs
419285-1-S-Frigidaire-134051000         -Drive Belt - 6 ribs 419285-2-S-Frigidaire-134051000         -Drive Belt - 6 ribs 419285-3-S-Frigidaire-134051000         -Drive Belt - 6 ribs http://www.partselect.com/Schematics/Frigidaire/SY9CMZMG.gif

Drive Belt - 6 ribs

PartSelect Number PS419285

This part works with the following brands: Frigidaire, Gibson, Kelvinator, Kenmore, Tappan & White-Westinghouse.

This part fixes the following symptoms:

  • Pumps but will not spin.
  • Will not agitate.
  • Spins slowly.
  • Noisy.
  • Compare At

    $20.20
  • You Save

    $3.37
  • Your Price

    $16.83
In Stock
Order within the next 3 hrs and your part ships today!
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.0 / 5.0, 3 reviews What's this?
1-3 of 3
 

39 of 55 people found this instruction helpful

Parts Used:
Level of Difficulty: Easy
Time to do repair: 30 - 60 mins
Tools: Screw drivers, Socket set, Wrench set
Customer: Carmen from Foreston, MN

Motor burned out, tub quit going around

First I turned off the water and disconnected the hoses. I took off the back panel and unscrewed the 4 bolts holding the motor in place. The grounding screw was impossible to remove, so I had to cut the wire off. Took out motor and disconnected the electrical connector. Put new motor in (ordered new belt, figuring it would need replacing - was still in excellent shape, but replaced it anyway), bolted in the motor (socket set works best on further away bolts, screwdriver for closer ones). Put the belt on the motor first and then pulled it up over the side of the tub and turned the tub to get it around the whole tub - took alittle bit of turning to get it on. Plugged in electrical connector and screwed grounding wire into hole. Replaced back panel and water hoses. Got a bit dirty and sweaty but not too hard to do it yourself, as I am a 48 yr woman and don't usually do this kind of thing.

Help other customers find the most helpful instructions.

Were these instructions helpful?

7 of 11 people found this instruction helpful

Parts Used:
  • Drive Belt - 6 ribs
Level of Difficulty: A Bit Difficult
Time to do repair: 30 - 60 mins
Tools: Nutdriver, Pliers, Screw drivers, Socket set
Customer: Alvin from Woodside, NY

Space

1. replaced (2) shocks, remove bottom cover 2. (1) spring and rib belt, used a wooden block to hold up drum , rolled out ld belt and rolled in new----remove top and rear covers after replaced same ---thanks..

Help other customers find the most helpful instructions.

Were these instructions helpful?

6 of 24 people found this instruction helpful

Parts Used:
Level of Difficulty: Really Easy
Time to do repair: 1- 2 hours
Tools:
Customer: Larry from Peoria, AZ

Door switch wouldn't allow machine to operate

disassembled cabinet to access, repl'ed switch with repl'mt sw. and harness provided. Instructions provided with repl'mt sw. made install very easy.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-3 of 3