418742-1-S-Frigidaire-131784700         -Tub-To-Pump Hose
418742-1-S-Frigidaire-131784700         -Tub-To-Pump Hose 418742-2-S-Frigidaire-131784700         -Tub-To-Pump Hose 418742-3-S-Frigidaire-131784700         -Tub-To-Pump Hose

Tub-To-Pump Hose

PartSelect Number PS418742

This part works with the following brands: Frigidaire, Gibson, Kelvinator, Kenmore, Tappan & White-Westinghouse.

This part fixes the following symptoms:

  • Leaking.
  • Compare At

    $54.14
  • You Save

    $9.02
  • Your Price

    $45.12
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.6 / 5.0, 3 reviews What's this?
1-3 of 3
 

13 of 18 people found this instruction helpful

Parts Used

  • Tub-To-Pump Hose

Level of DifficultyEasy

Time to do repair:30 - 60 mins

ToolsPliers, Screw drivers

CustomerLarry from East Point KY

Washer would leak water out the bottom.

First I removed the two screws holding the front panel on and removed the panel. The hose is held on by two spring clips and a hose clamp. After getting those out of the way, I removed the damaged hose and slid the new one into place and fastening it down with the aforementioned clips and clamp.

Help other customers find the most helpful instructions.

Were these instructions helpful?

6 of 8 people found this instruction helpful

Parts Used

  • Tub-To-Pump Hose

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsPliers, Screw drivers

CustomerBarbara from Los Angeles CA

Tub to pump hose leaking

From the front of the washer, I removed two sheet metal screws at the bottom of the access panel. The panel pulled off with a just a little effort due to the nylon inserts installed on either side of the panel that keep it in place. The tub-to-pump hose is located on the right hand side and easy to access. The hose includes a screw clamp and two tension retainer (?) clamps that need to be removed.Make sure to save them for the new hose! I used a phillips head screwdriver for the screw clamp and a pair of channel locks to remove the tension retainer clamps. The tension retainer clamps were easy to remove but tricky to put back on. There must be another tool used for them that I'm not familiar with. With just a little patience though, it's an easy enough repair for anyone to do.

Help other customers find the most helpful instructions.

Were these instructions helpful?

3 of 5 people found this instruction helpful

Parts Used

  • Tub-To-Pump Hose

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsPliers

Customermike j from merritt island FL

Tub to pump hose (coin trap) was leaking

I was hoping it was the drain hose but it wasn't. It's a front load washer so I pulled the kick plate in the front (2 screws) removed the three clamps and put the new hose on. Easy job, saved a hundred or so from the repair man. Part cost 35 bucks!

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-3 of 3