Part Location Diagram of 131758600 Frigidaire Timer
See part F8 in the diagram
( Grid squares measure 1x1 inch )
Customer Service Representative

Get in touch, we're here to help!

Daily 8am - 9pm EST

customerservice@partselect.com

Timer 131758600

 Fits your FWS235RFS2!

Rated by 5 customers 

Easy 

30 - 60 mins 

Ratings submitted by customers like you who bought this part.

$ 249.58
  In Stock
Get FREE EconoShip on orders over $100! T&C apply

Get this part fast! Average delivery time for in-stock parts via standard shipping: 1.8 days.

 Fits your FWS235RFS2!
PartSelect Number PS418697
Manufacturer Part Number 131758600
Manufactured by Frigidaire
Product Description

Timer Specifications

The timer controls most of the operations of the washer: water level, tub filling and emptying, length of cycles, and cycle setting sequences.
How Buying OEM Parts Can Save You Time and Money

How Buying OEM Parts Can Save You Time and Money

Troubleshooting
This part works with the following products:
Washer Dryer Combo, Washer.
This part works with the following products:
Frigidaire, Westinghouse, Gibson, Crosley.
Part# 131758600 replaces these:
AP2107583, 408188, 131758600
Back to Top
Customer Repair Stories
 Average Repair Rating: 3.2 / 5.0, 5 reviews. What's this?
Sort by:
  • 1
Sorry, we couldn't find any existing installation instruction that matched.
Timer for washer did not work(would not cycle without me moving the dial)
I removed control panel(washer and dryer controls since this is a combination unit) from the front by undoing screws at access panel and unplug the washer/dryer unit,220 volt if all electric like mine and then 4 phillip screws at bottom of control panel- 2 large phillips and 2 small phillips at outer edges underneath at plastic ends this will allow you take off the panel. Then pull panel out and turn over to get at back of timer /cycle control and pull pen back at dial, this will allow you to remove the the knob. I didn't know this at first so I had quite the battle going on removing the knob! Then I read someone elses letter and at the bottom he talked about the pulling of pen on back. If you do this you won't have to replace your knob like I did.Once you pull the knob off there is a small screw just to the inside you will have to remove and this will allow the timer to come off.disconnect the plug and insert new timer and re-install reversing the steps. Replug washer dryer and you are done. Good Luck!
Other Parts Used:
Timer Timer Knob - Washer
  • John from Covina, CA
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
52 of 55 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Washer would not advance on cycles
Had an electrician friend to do the removal and repair
  • Bruce from Newport Beach, CA
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Screw drivers
7 of 21 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Timer made noise but would not move
A bit iintimidating in trying to get the knob off the timer without breaking it. finally discovered the plastic tip that went straight thru to the back, pulleed it out and walla walla the knob came off easily. Getting to the timer was a bit interesting, was not sure how far I had to tear down the washer/dryer combo front. Once I got to the part it was easy to do. I have three of these machines, two in my daughter's houses so now am dconfident i can repair if needed. Got the wrong part at first and had tosend back for the right on, got the timer for the dryer first. Expensive parts.....
  • calvin from tomball, TX
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Pliers, Screw drivers
7 of 8 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
timer wouldnt clock it would just keep washing & washing
I removed the screws holding the access cover in place than the screws in the plastic ends than the screws at the bottom edge of the control panel pulled the button on the back of the timer removed the handles than one screw under the handle area to remove the timer it was easy
  • Chuck from Centralia, IL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
7 of 8 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
tub won't drain& timer control won't go to correct setting
To replace the pump remove to lower screws on the front panel,remove panel ,pump is in the front section , remove two screws that attach pump to lower housing.
To replace timer remove screws on the plate that the contrlos on mounted on. Once you have access to timer you must remove the nylon pin in the back of the timer that holds the dial to the timer base.You can not remove the knob without removing the pin
Other Parts Used:
Drain Pump - 120V 60 Hz. Timer
  • big fred from prospect heights, IL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    1- 2 hours
  • Tools:
    Nutdriver, Pliers, Screw drivers
14 of 17 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
  • 1
Questions and Answers

Ask our experts a question about this part and we'll get back to you as soon as possible!

1 question answered by our experts.
Sort by:
  • 1
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
TERESA
November 6, 2017
Will not agitate nor go thru the agitate sequence. Will fill, drain and spin. Can it be the timer?
For model number FEZ831AS1
PartSelect logo
Hi Teresa, Thank you for your inquiry. The timer is one part you will need to check, but there are some other parts that you will need to check to see which one is causing the issue as well. You will need to check the agitator, the drive belt, the transmission, the drive motor and the washer lid lock with external safety switch, the rotary switch and the pressure switch. I hope this helps. Thank you and have a great day!

Was this helpful?
Thank you for voting!
  • 1
Model Cross Reference
This part works with the following models:
PartSelect Number: PS418697
Manufacturer Part Number: 131758600
Brand
Model Number
Description
Crosley
CLCE500FW0
Washer Dryer Combo
Crosley
CLCE500FW1
Washer Dryer Combo
Crosley
CLCE500FW2
Washer Dryer Combo
Crosley
CLCG500FW0
Washer Dryer Combo
Crosley
CLCG500FW1
Washer Dryer Combo
Crosley
CLCG500FW3
Washer Dryer Combo
Crosley
CTW100FW0
Washer - Residential
Frigidaire
FEX831CS0
Washer Dryer Combo
Frigidaire
FEX831FS0
Washer Dryer Combo
Frigidaire
FEX831FS1
Washer Dryer Combo
Frigidaire
FEX831FS2
Washer Dryer Combo
Frigidaire
FEZ831AS0
Washer Dryer Combo
Frigidaire
FEZ831AS1
Washer Dryer Combo
Frigidaire
FEZ831AS2
Washer Dryer Combo
Frigidaire
FEZ831CFS0
Washer Dryer Combo
Frigidaire
FEZ831CFS1
Washer Dryer Combo
Frigidaire
FGX831CS0
Washer Dryer Combo
Frigidaire
FGX831CS1
Washer Dryer Combo
Frigidaire
FGX831FS0
Washer Dryer Combo
Frigidaire
FGX831FS1
Washer Dryer Combo
Frigidaire
FGX831FS2
Washer Dryer Combo
Frigidaire
FGX831FS3
Washer Dryer Combo
Frigidaire
FGX831MCS0
Washer Dryer Combo
Frigidaire
FGZ831AS0
Washer Dryer Combo
Frigidaire
FGZ831AS1
Washer Dryer Combo
Frigidaire
FGZ831AS2
Washer Dryer Combo
Frigidaire
FLEB43RGS1
Washer Dryer Combo
Frigidaire
FLEB43RGS2
Washer Dryer Combo
Frigidaire
FLEB43RGS3
Washer Dryer Combo
Frigidaire
FLGB43RGS1
Washer Dryer Combo
Customer Service Representative

Get in touch, we're here to help!

Daily 8am - 9pm EST

Contact Customer Service