15 of 25 people found this instruction helpful
Level of Difficulty: A Bit Difficult
Time to do repair: More than 2 hours
Tools: Nutdriver, Pliers, Screw drivers
Customer: Chris from Toccoa, GA
Drum loose, causing high pitch noise.
First use a vacum to remove all the dust and lint inside the dryer fraim
Some problims removing old rear drum bearing assembly. Also removing old drum guide bottom Adhesive.
I used a new wire brush, but if I had a brush that fit a drill this would have been better to remove the adhesive.
I then applied the Glue, drum seal and small clamps to hold in place so the glue could dry overnight the next day 30 mins and the dryer was back togeather.
38 of 169 people found this instruction helpful
Level of Difficulty: Easy
Time to do repair: 30 - 60 mins
Tools: Screw drivers, Socket set
Customer: Patrick from Humble, TX
Squeeking/ grinding really bad
First I pryed up the top cover then opened the access cover on the rear to remove the belt from the drum. Next I removed the front of the dryer to have access to remove the drum. I then removed the 3 screws that hold the drum to the rear drum bearing assembly and pulled the drum through the front of the dryer. I then removed the bearing and proceded to remove the ground ball and reassembled in reverse steps.