Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS416946
The gasket is used to help keep in the hot air in the dryer from escaping and to prevent the cool air from entering in to the dryer.
This part works with the following brands: Frigidaire, Gibson, Kelvinator, Kenmore, Tappan & White-Westinghouse.
First use a vacum to remove all the dust and lint inside the dryer fraimSome problims removing old rear drum bearing assembly. Also removing old drum guide bottom Adhesive. I used a new wire brush, but if I had a brush that fit a drill this would have been better to remove the adhesive.I then applied the Glue, drum seal and small clamps to hold in place so the glue could dry overnight the next day 30 mins and the dryer was back togeather.
Help other customers find the most helpful instructions.
Were these instructions helpful?
removed the old gasket with pliers (noting where the beginning/end of the gasket was) then installed new gasket in the exact location with very light pressure on each rubber insert point. Voila!!
First I pryed up the top cover then opened the access cover on the rear to remove the belt from the drum. Next I removed the front of the dryer to have access to remove the drum. I then removed the 3 screws that hold the drum to the rear drum bearing assembly and pulled the drum through the front of the dryer. I then removed the bearing and proceded to remove the ground ball and reassembled in reverse steps.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.