401566-1-S-Whirlpool-9703241           -Lid Seal
401566-1-S-Whirlpool-9703241           -Lid Seal 401566-2-S-Whirlpool-9703241           -Lid Seal

Lid Seal

PartSelect Number PS401566

Used on Blenders.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

This part fixes the following symptoms:

  • Touchpad does not respond.
  • Compare At

    $12.06
  • You Save

    $2.01
  • Your Price

    $10.05
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 5.0 / 5.0, 2 reviews What's this?
1-2 of 2
 

17 of 19 people found this instruction helpful

Parts Used

  • Lid Seal

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

CustomerEulyess from Grand Prairie TX

Worn out lid seal on blender

I only had to use my hands to install the the new lid seal and the new lid seal fit perfectly. The old original seal was made of foam & would not come clean. The new lid seal is rubber; that's what the blender should have come with when new.

Help other customers find the most helpful instructions.

Were these instructions helpful?

8 of 15 people found this instruction helpful

Parts Used

  • Lid Seal

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

CustomerKen from Kent WA

Blender jar leaks due to worn gasket

I retrieved the package from under the doormat where the FedEx driver had left it. Using a utility knife, I carefully cut open the package but accidentally cut into the included packing slip. I removed the seal from the outer packaging and using the same knife carefully cut open the plastic bag containing the seal, being careful not to cut the seal itself. I removed the seal from the packet and removed the lid from the blender jar by turning it a few degrees counterclockwise by hand. Using my fingers, I removed the old seal from the lid and then using those same fingers I laid the new seal in place. Then slapping myself in the forehead, I realized I should probably wash the new seal before using it because you just never know who has handled it. So I reversed the installation process and after washing the seal with mild soap and water, I re-installed it on the lid using the same finger process. The next step was to re-install the lid on the jar by turning it a few degrees clockwise until it locked into place. The last step was to congratulate myself for a job well done by cracking open a beer while at the same time cursing myself for spending $16 on a stupid rubber seal.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-2 of 2