Spray Arm Seal

I removed broken mount by gently bending tabs, pressed new mount into upper dish rack, attached the spin arm and secured the mount with the screw.

A snap---it took less than 2 minutes after only a two day turnaround from ordering the part to receiving it at home..

Fantastic service. Thanks!!!!

Remove upper tray and spray arm. Remove two screws retaining pipe for upper spray arm and overhead. Unscrew retainer on top of lower spray arm and remove. Gently rotate the upper feed pipe clockwise until pipe can be removed from lower pipe. You may then remove the lower pipe and bearing housing where the seal is. Reverse order for reassembly. I also replaced upper spray arm bushing. Very simple, remove one screw and the arm will come out.

I first replaced the door balance kit. I had to unhook the water supply to pull the unit out. I replaced the door balance kit first. The pieces were slightly different than my old parts, but fairly easy to figure out. Also, the spring was off on one side so had to confirm where to reconnect it. That took about 30 minutes. I then took out the racks and installed the chopper. The old one came out easily, but it took about 20 minutes to seat the new chopper properly and then reassemble the lower arm. This part of the repair was about another 30 minutes total. Lastly, I replaced the upper rack adjusters, which had broken a while ago and I had pulled together with nylon straps. The new adjusters have metal screws which should be more durable than the plastic clips used in the original equipment. This part of the job took about another 20 minutes, but was easy to complete. The dishwasher door works like new and the top rack is easier to load with the adjusters working properly again.

removed parts and the ordered the parts. It was very easy to order parts from Partselect. I unscrewed a few screws and the disassembly was a breeze. I then revresed my steps and the new parts were instlalled no problem. Now on the the motor replacement. Thanks Partselect.com