| |
14 of 14 people found this instruction helpful
Parts Used
-
- Burner Grate Pads - Kit of 5
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
Tools
CustomerSabrina from Mooresville NC
Several grate pads fell out/lost /broke during cleaning
The only real issue was locating the proper adhesive to ensure that the new pads would not fall out. The small insert paper slip in the package noted that a RTV adhesive should be used. After much searching at the home improvement super store, I learned it would be found at an auto supply store. It is black, and is for high temp use. It is available in a small tube for around $2.00. The RTV is usually used to make gaskets for heat/oil exposure in auto repair. I did have trouble removing a broken stub from a pad that had broken off in the hole. I used an awl to get what I could and push the rest into the hole deeper, then insert a new pad with along with the adhesive.
|
12 of 19 people found this instruction helpful
Parts Used
-
- Burner Grate Pads - Kit of 5
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
Tools
CustomerMelissa from The Woodlands TX
Rubber pads on bottom of grate broke off, grate was scratching stainless steel top
I just put the grate pads in the bottom of the grate. The repair was a snap.
|
5 of 6 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
Tools
CustomerHugh from Fort Collins CO
Burner grate pads came off over time and were lost, knob skirt clips had broken
attached grate pads with GE clear silicone caulk (withstands heat) to burners. skirts just snap in.
|
3 of 3 people found this instruction helpful
Parts Used
-
- Burner Grate Pads - Kit of 5
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
Tools
CustomerMartin from Denver CO
Missing bumper pads
Original bumper pads NOT glued into the burner grates. Hence they began to disappear during routine use and cleaning. Very simple repair with a little glue this time around. But fairly expensive for a very small part set
|
2 of 2 people found this instruction helpful
Parts Used
-
- Burner Grate Pads - Kit of 5
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
Tools
CustomerKaren from Palm Desert CA
Pads melt and fall out of the burner grate
cleaned out pad area with an awl. then the pads just slide in.
|
2 of 2 people found this instruction helpful
Parts Used
-
- Burner Grate Pads - Kit of 5
Level of DifficultyReally easy
Time to do repair:30 - 60 mins
Tools
CustomerRobert from Rio Rancho NM
Grate pads not available from kitchen aide
Been looking for grate pads for 10 years and finally found you site and part # WPL 814323.
Wasn't sure that they would fit but couldn't even find new grates so decide to try them --Fit perfect.
Kitchen aide stove top gas with round grates. Used the drill to clean out the holes with broken pads still embedded.With clean holes the new pads just screwed in like the originals. Thank you very much
|
2 of 3 people found this instruction helpful
Parts Used
-
- Burner Grate Pads - Kit of 5
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
Tools
Customerjoe from des plaines IL
Missing grate pads
remove grate - flip upside down - be sure holes are clean and dry - using toothpick, swab some RTV sealant into the holes and a bit on the pads ... insert pads till they seat - be sure to hold in place till all air is evacuated - wipe excess RTV with paper towel...DONE
|
2 of 3 people found this instruction helpful
Parts Used
-
- Burner Grate Pads - Kit of 5
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
Tools
CustomerChristie from Provo UT
Grate pads were gone, making cleaning difficult
Put the new pad in and it was done. Very easy.
|