389156-1-S-Whirlpool-814269            -Flat Style Oven Igniter
389156-1-S-Whirlpool-814269            -Flat Style Oven Igniter 389156-2-S-Whirlpool-814269            -Flat Style Oven Igniter 389156-3-S-Whirlpool-814269            -Flat Style Oven Igniter

Flat Style Oven Igniter

PartSelect Number PS389156

This igniter is lighted by the spark switch to produce a flame to ignite the oven.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

This part fixes the following symptoms:

  • Gas igniter glows, but will not light.
  • Will Not Start.
  • Little to no heat when baking.
  • Compare At

    $69.58
  • You Save

    $11.60
  • Your Price

    $57.98
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.0 / 5.0, 2 reviews What's this?
1-2 of 2
 

15 of 23 people found this instruction helpful

Parts Used

  • Flat Style Oven Igniter

Level of DifficultyEasy

Time to do repair:30 - 60 mins

ToolsNutdriver, Pliers, Screw drivers

Customerjames from long beach NY

Ignitor glowed but did not ignite

took oven base plate out. diconnected ignitor , put new clips on neutral wire as per instructions, inserted new ignitor, put everything back, worked ok.

Help other customers find the most helpful instructions.

Were these instructions helpful?

6 of 12 people found this instruction helpful

Parts Used

  • Flat Style Oven Igniter

Level of DifficultyEasy

Time to do repair:1- 2 hours

ToolsScrew drivers

CustomerDwayne from Mesquite TX

Igniter turned red but oven would not light

Remove broiler pan, disconnect wires from igniter to gas safety valve and connection in back corner of stove, under a metal plate held in with one screw. Remove two screws holding igniter in and take it out. With new igniter, cut neutral wire as per instructions with it, attach electrical clips to the wire ends, install the new igniter with the two screws, plug in the two wire clips to the safety valve just below the igniter and plug in the plastic clip with both wires going into it over in the corner of the stove, and replace the cover over that connection with the one screw, which you removed at the beginning of this process, and you're done.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-2 of 2