Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS382824
This kit has been redesigned. The supply tube is now one piece. This spray arm kit comes with an upper spray arm, holder, water supply tube and a screw. This kit does NOT include the upper support or mount.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
This part fixes the following symptoms:
**Please note: This is a redesigned part. The top mounting clip and screw are no longer needed.
All you had to do was slide the top rack out, remove the end clips and remove the rack. Once the rack was out you flip it over remove the screw holding the arm, remove the old arm and screw in the new arm. Make sure your clearance is good, slide the rack back into the dishwasher and replace the end clips.
Help other customers find the most helpful instructions.
Were these instructions helpful?
Removed spray arm and replaced new spray arm with the help of u-tube video.
I left the repairs in my husbands capable hands and walked away. I now have a "new" dishwasher. Thank you for having what was needed.
Very simple, I trashed the old parts and connected the new parts with only one tool, a Phillips head screwdriver.
Removed old and replaced with new. However, my records show that I ordered the bottom rack and spray arm kit. Part Select sent the top rack with the spray arm attached. Rather than returning the parts, i used the top rack and put the spray arm kit into my household inventory. I may try again later for the lower rack.
Started with Sears and they sent the wrong part. Found Parts Select on line and they sent what I needed.First i removed the upper tray by removing the end clips on the sliders to give me access. I then removed the old spray arm by removing the upper and lower screws. I installed the new spray arm, snapped on the supply line retainer and reinstalled the upper tray.Easy as pie with the right parts.
I removed the old spray arm, using a screwdriver and plier. I found it easier to do this after I removed the whole upper tray, which I was able to do after popping out the cotter pins on both sides of the tray and turning the tray upside down. Then I installed the new spray arm kit, using just a screwdriver (it only goes in one way), reinstalled the tray and cotter pins and was done. One caution, make sure the clip holding the hose is mounted exactly where it should be or the new spray arm will not spin. Just check to make sure it spins properly.
Replaced old spary arm assembly and replaced with new one.
Installed all parts. Dish washer still leaks. Wasted my time and money.
Removed the top rack by unclipping four clipsRemoved hexhead screw that held the spray arm and tube to the rackInstalled new spray arm and tube reusing original hex screwReinstalled top rackSwitch out broken Tine Flexrow clipsReplace lid on silverware baskets and set into place
I removed the old spray arm and supply tube using a pair of pliers. Next I installed the new items in the reverse order. The final step was to align the supply tube with the water outlet in the back of the dishwasher. The bracket that came with the spray arm was east to install and aligned the parts perfectly. All in all a very easy and satisfying repair....
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2016 , Eldis Group Partnership. All rights reserved.