Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS382824
This kit has been redesigned. The supply tube is now one piece. This spray arm kit comes with an upper spray arm, holder, water supply tube and a screw. This kit does NOT include the upper support or mount.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
This part fixes the following symptoms:
**Please note: This is a redesigned part. The top mounting clip and screw are no longer needed.
Layed the parts on table to get the right setup,and then installed with no trouble.
Help other customers find the most helpful instructions.
Were these instructions helpful?
Well the first part I ordered (Middle Spray Arm Kit) did not come with the Upper Arm Mount Bracket which is what I needed so I had to call and order it after waiting 6 days for the middle spray arm kit which I didnt really need.If yours breaks check it out by unscrewing the screw on the bottom of you Upper arm bracket and you will see what the problem is. Once you see all you need is the Upper Arm Mount order it and be watchful when installing. It is not like the video. You have to assure that you have the mount angle to the left or your spray arm will not spin.
took off the old parts and installed the new parts.
Dishwasher 9 years old and the replacement parts were re-engineered to make installation easier. It took about 30 minutes to install the new spray arm kit. Once I ordered the parts, they were here in two days...even though regular shipping was requested. I will continue to use partselect to order parts for anything in this house I can repair. The parts cost $35. A repair service would have been $150.
took old out and installed the new one
The repair should have taken 5 minutes but I did not realize that the clip had a front and a back - so check that before you remove the old clip as the rod the spray arm spins on is angled and it will stick if you mount it the wrong way. Also the clip has been redesigned so you do not need the little cover - if you buy the spray arm kit PS382824 it is all you need - good luck!Repair man wanted $250 - I did it for $40.00 and bought an estra $2.30 cent part!
Replaced with one-piece unit made of upgraded material. The two mounts did not match. Luckily, the old mounts were of good material allowing me to reuse them. Did not return the unmatched mounts because the inconvenience wasn't worth the effort or cost. Unit works like new now.
No Brainer. Watch that the support bracket is oriented so the arm spins without restriction.Use the small pliers to remove the brackets, or a flat head screwdriver.
Removed old screw with nut driver. Replaced part and screwed in new part. Was a lot easier than I had anticipated.
Worst part of the repair was removing the old screw. Everything else went great
I took out the old spray arm using the nutwrench and put the new one in the exact same way the old one came out.
Easy to install, fixed for only $30.00 and did not need to call a repair man. Saved a bunch of money. Parts fit perfect. Shipped very quick. Thanks parts select.
Ordered a new spray bar kit with all parts needed
Removed the retaining clips on the upper rack supports.Removed upper rack from the dishwasher, set it on a flat surface.Removed the upper screw from the spray arm bracket.Turned upper rack over.Removed the lower screw from the spray arm.Removed parts from dishwasher.Assembled the new spray arm, supply tube and bracket and followed the same steps in reverse order.
replaced the entire spray arm kit.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2016 , Eldis Group Partnership. All rights reserved.