| |
13 of 19 people found this instruction helpful
Parts Used
-
- Halogen Light Bulb - 5W 12V
Level of DifficultyEasy
Time to do repair:Less than 15 mins
ToolsScrew drivers
CustomerLee from Loveland CO
Light bulb out in oven
Removed a screw and clip to remove the lens and replaced bulb. Then replaced clip and screw. Done.
|
7 of 13 people found this instruction helpful
Parts Used
-
- Halogen Light Bulb - 5W 12V
Level of DifficultyA Bit Difficult
Time to do repair:15 - 30 mins
ToolsScrew drivers
CustomerEric from Camas WA
Microwave light-bulb went out
First, I removed the grill from the top of the microwave by removing 3 screws and then by sliding it out. It was a bit tricky, but you have to rotate it under so the grill comes out from behind the display.
Next, I removed the bottom grill by removing 4 screws. This one removed easily. Then, I removed 2 more screws that were under the bottom grill and was able to start sliding out the microwave unit.
I was only able to pull the microwave half way out because some wires were stopping me from pulling it out more. I removed the big square piece of insulation and had enough room to get to the light assembly.
I removed the retaining clips by pushing the right side of the clips to the little opening in the middle on the right hand side. Then I was able to remove the light bulb and replace with the new one.
|
1 of 2 people found this instruction helpful
Parts Used
-
- Halogen Light Bulb - 5W 12V
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
Tools
CustomerRex from Amarillo TX
Oven lights out
There are two lights in this model oven. The glass will open by pulling outward on the near end. Since these are halogen bulbs I used a clean cloth to hold the bulb while replacing. Bulbs are expensive especially when purchased from Kitchen Aid dealer. I got two bulbs from PartsSelect delivered in two days for considerably less.
|
2 of 6 people found this instruction helpful
Parts Used
-
- Halogen Light Bulb - 5W 12V
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsScrew drivers
CustomerROBERT from ELMIRA NY
Replace halogen bulb
USED FLAT TIP SCREW DRIVER TO PRY FRONT CLIP HOLDING GLASS COVER OUT OF POSITION. PULLED OUT DEAD BULB AND PUSHED IN NEW ONE. SLID CLIP BACK ON GLASS COVER AND SLID BACK INTO PLACE. SIMPLE..
|
0 of 1 people found this instruction helpful
Parts Used
-
- Halogen Light Bulb - 5W 12V
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsScrew drivers
CustomerJames from Burlingame CA
Oven light went out
Turned out the oven light bulb were not the problem and am awaiting callback about what needs to be done to get the lights working again.
|
2 of 7 people found this instruction helpful
Parts Used
-
- Halogen Light Bulb - 5W 12V
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsScrew drivers
Customerstephen from middleboro MA
Change bulb
removed double wall oven light lens install bulb replace lens fini
|