Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS373025
This flat style igniter comes with a wire harness connector. This part ignites the gas within the dryer. Bracket is NOT included.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
This part fixes the following symptoms:
I removed the front panel from the dryer and observed that the glow plug was not getting hot when the dryer was turned on. I removed the glow plug and verified that power was present using an OHM meter. Power was present. I could also see a hairline crack in the glow plug. The new glow plug took about 2 minutes to install and immediately glows red when the dryer is turned on. Easy fix.
Help other customers find the most helpful instructions.
Were these instructions helpful?
Per instruction found in the internet about the simptoms and recomended parts wich ussualy goes bad in that model I follow the intructions of a tecnitian to replace the igniter and the termal fuse.
I went to a repair website to see what some of the problems could be and tested for them. I checked the power starting at the circuit breaker box and went all the way to the igniter. I discovered that the igniter had a small break in it and determined that that was the cause for dryer heat not coming on.
I checked the sensor and other components for continuity and found they all worked ok. I check the Igniter and found no continuity or resistance. That was the problem. Installation was easy. One screw and a two wire plug.
my husband took the old igniter out and put the new one in and it was fix. your websit was very easy and very resonable price. thank for your help
Removed the front cover of the dryer. Unpluged the igniter and then removed srcrew and replaced with new igniter.
Removed the front of dryer and replaced igniter, old igniter was in bad shape, but it did not fix problem. Looks as if I need to replace gas valve assembly also.
It took me about 20 minutes to figure out how to remove the front cover, and 10 minutes to remove and replace the ignitor. Works like a charm. Saved me lots of money. $$$$$$$$$. Thanks for the information.
ordered and replaced igniter. problem fixed
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2016 , Eldis Group Partnership. All rights reserved.