Quick Question!

Have you ever purchased from PartSelect.com before?

372261-1-S-Whirlpool-4388932           -Electronic Defrost Control Board with Wire Harness and Screws
372261-1-S-Whirlpool-4388932           -Electronic Defrost Control Board with Wire Harness and Screws 372261-2-S-Whirlpool-4388932           -Electronic Defrost Control Board with Wire Harness and Screws 372261-3-S-Whirlpool-4388932           -Electronic Defrost Control Board with Wire Harness and Screws http://www.partselect.com/Schematics/Maytag/NWXRHLGM.gif

Electronic Defrost Control Board with Wire Harness and Screws

PartSelect Number PS372261

This part is located in the control box in the refrigerator.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

This part fixes the following symptoms:

  • Fridge too warm.

Compare At

$190.44

You Save

$31.74

Your Price

$158.70
Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.8 / 5.0, 2 reviews What's this?
1-2 of 2
 

42 of 65 people found this instruction helpful

Parts Used:
  • Electronic Defrost Control Board with Wire Harness and Screws
Level of Difficulty: Really Easy
Time to do repair: Less than 15 mins
Tools: Nutdriver, Screw drivers
Customer: RONALD W from CARSON, VA

Ref-freezer was clicking off & on

i have gotten parts from partselect before, foung model # & looked up on there web,found it, ordered,and received next day, pulled plate off of front, removed screws undone clip & and replaced part works find very good company to deal with

r w reese

Help other customers find the most helpful instructions.

Were these instructions helpful?   

25 of 34 people found this instruction helpful

Parts Used:
  • Electronic Defrost Control Board with Wire Harness and Screws
Level of Difficulty: A Bit Difficult
Time to do repair: 30 - 60 mins
Tools: Pliers, Screw drivers, Socket set
Customer: Robert from Russellville, AR

Refrigerator stopped working

Used a volt meter to determine if compressor was getting power. It was not. There were only two wires going to compressor so I partially unloaded frige and disassembled unit until I found the control circuit. I removed the control board and could not find any degraded connections so I thought it was most likely the relay installed on the board. I determined which connection was the normal power feed and decided that the relay should power one of two outgoing lines when it picked up. I jumpered from power to the most likely line and powered up the refrigerator and it worked. I cycled the breaker to maintain temperature until the new part arrived (about 2 days). I installed the new board in about 30 minutes and everything is working great. Looking forward to another 15 years with this refrigerator. It may be destined for the garage in a few years when we remodel the kitchen but it will make a fine shop frige!

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1-2 of 2