Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS372186
This white ice bin auger drum comes with a washer.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
This part fixes the following symptoms:
First I removed the 6 screws and then 2 more--being carefull to take cap off inside to nremove metal blades--be sure to keep in order--taking ba digital picture helps at this point--make sure to put back nin reverse order after replacing washer and new auger--went smooth thanks appliance parts repair service forum--Rick--Enjoy your own repair!!!
Help other customers find the most helpful instructions.
Were these instructions helpful?
This was not a hard repair. Just remove all the screws and slide out the old Auger drum. It is always good to take a picture first incase you have any problems putting it back together. Be careful to put the ice crushers back in the same order and make sure you look at how the "door spring" connects before pulling it apart.
Took the Ice Bin Out emptyed it then removed the nesasary screws pulled the broken Peice off and sliped the new part on held the metal peices together so we would know how to keep them in order for fear of putting them in wrong place but we did it now it works great thank you so much for getting the part to me so quickly your great.
The video for the repair was very helpful and made the repair go very well. It works just like new!!
new auger and drive wheel
Remove ice bin,remove screws that hold the cover, then remove circlip at the end of the shaft.Remember to stack grinder blades and spacers in the order they come off ,then remove plastic nut that holds the auger . Remove broken auger and install new one then reinstall grinder blades as you removed them . Insert shaft back into bin and replace cover. Place ice bin back in Frig. and your done. The ice guide just snaps in . Jr.
Be very, very careful to mark, or make record, of each element as they are removed. For the system to work, the metal "crusher" and dispenser parts must be reinstalled in the exact position as taken out. If you can visualize the assembly, you will note that arms in the drum are placed in a way which allows cube or crushed dispensing. Besides making a schematic, I took a picture which helped me. Of course I am not a real refrigerator repair guy, and had to take the extra steps.
I removed the external shaft that controls the ice grinder. Its spring loaded so you have to remember how to get it back together. I removed the screws that hold the cover in place. I removed the nylon nut that holds the drum and grinder on the center shaft. I replaced the drum and reversed the procedure.
auger blade was replace
The door bin wasd a snap just take out the old and put in the new. The Ice bin auger was a little difficult because when we took out the ice crusher part we had problems putting it back to it would contine to cruch, it is still off some but on a whole I now can get ice from the door again. I could have used better directions on taking out the old and replaceing it.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.