| |
7 of 12 people found this instruction helpful
Parts Used
-
- Compressor Relay and Overload Kit
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsNutdriver, Screw drivers
CustomerSAL from UPLAND CA
Refrigerator stop working
First I removed the relay and over load and exam. Saw that the relay was burnt. Before I order the part I check to see if the compressor was still working by jumping the common start and run terminals.It did. I also checked the start capacitor with a capacitor tester it was good. I than order the part which came the very next day.Installed the part
|
2 of 6 people found this instruction helpful
Parts Used
-
- Compressor Relay and Overload Kit
Level of DifficultyEasy
Time to do repair:30 - 60 mins
Tools
CustomerMike from Sherman CT
The compressor did not kick in....
The repair was easy......however I had no help to identify the problem and after I did I had no description or schematic of how to connect the parts. The old defective part was not identical to the new one. some written material would have been helpful.
Z. Benedek
|
2 of 7 people found this instruction helpful
Parts Used
-
- Compressor Relay and Overload Kit
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsScrew drivers
CustomerRobert from Boxborough MA
Change relay
unplugged relay and plugged in
|
0 of 2 people found this instruction helpful
Parts Used
-
- Compressor Relay and Overload Kit
Level of DifficultyReally easy
Time to do repair:15 - 30 mins
ToolsPliers, Screw drivers
CustomerBobby from New Bern NC
After hurricane irene refrigeration compressore did not start
Followed the directions. Installation was quick. Took loner to put the covers back on and push the applicance back in position than the repair.
|
1 of 6 people found this instruction helpful
Parts Used
-
- Compressor Relay and Overload Kit
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsNutdriver, Screw drivers
CustomerOliver from Madison AL
Cimpressor would not start
Checked compressor with amp meter, and found it was not running, found Overload Switch bad.
When removing old switch watch carefully which lug you move wires from, so you will know which
lug to put the new switch on.
BE SURE YOU KNOW SOMETHING ABOUT
ELECTRICITY!!
|
0 of 7 people found this instruction helpful
Parts Used
-
- Compressor Relay and Overload Kit
Level of DifficultyReally easy
Time to do repair:30 - 60 mins
ToolsPliers, Screw drivers
CustomerGeorge from Conroe TX
Starting relay went out
Forty years ago I serviced air conditioners and all kinds of refrigeration. At that time starting relays were electro mechanical, I hadn’t looked under a refrigerator in a lot of years and was surprised to find out that the new relays were solid state. The defective one had a bunch of broken pieces floating around in the case. I jury rigged a starting cord and confirmed that the compressor would start and looked at running current for thirty or so seconds. I ordered a new relay kit and it worked just right. I’m seventy five years old and it takes me longer to get up off the floor than it took to replace the parts. Your delivery was first rate the parts got here before I finished doing the paint touch-up on the door under the ice maker/water dispenser. Fed ex was easily three to five days faster than the brown truck.
|