Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS3654187
This dryer timer is used to control the unit's cycles by regulating the length of time that power is directed to each setting.
This part works with the following brands: GE, Hotpoint & Kenmore.
This part fixes the following symptoms:
1. Remove three screws from back of dryer2. Tilt top panel forward and disengage 3. Swapped wiring one by one from old timer to new timer4. ReinstallThe new timer worked so well that even the old, broken knobs could turn it. But I replaced the knobs anyway.Customer service was great in helping me verify that this timer would work on this dryer (my model number was not listed on the website).
Help other customers find the most helpful instructions.
Were these instructions helpful?
I took the top back panel off the dryer and left the broken timer still connected to the wires, I then took the wires off one-by-one to match the connections on the new timer. Be sure to not pull the wires by hand , use pair of needle nose to grab the wire by the connector itself, wiggle gently to pull off the wires. Job took about 10 minutes, very easy.
Replace time and labeled each wire I disconnected
Unplugged dryer from power source. Unscrewed holding plate (1-screw) and back plate (5-screws). Took photo of old timing unit while it was still mounted on the dryer to show wire correct wire connections. Used needle nose pliers to remove connecting wires one at a time from old timing unit and attached them to new timing unit. Reinstalled back plate and holding plate.
Unplugged the old wire and connected new one at a time placed new timer back in position. Screwed cover back on and started drying clothes.
I followed instructions l read online worked perfectly
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.