Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS356593
NOTE: This part requires a silicon sealant for installation.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
This part fixes the following symptoms:
Bent back metal ears over door hinge pins, released door springs from door hinges. Lifted door off of hinges and replaced corner drain back seals and lower door seal.Still leaks so obviously I have another issue or the door seal is lousy quality. I've completed this project before and never had another issue for 6 years.
Help other customers find the most helpful instructions.
Were these instructions helpful?
First replaced long seal on door bottom by pulling old out by hand. Snapped new seal in. Detached door springs. Used screwdriver to spread bracket wider to allow door hinge pins to clear bracket and lowered door. Removed old seals on bottom sides of unit by hand, snapped new ones in. New ones slightly larger than original but work fine. Attach door, close bracket holding door pins with screwdriver and reattach springs.
These parts were VERY easy to install. The dishwasher works perfectly now.
Read you insructions . Lowered the door. Pull up the door meatlhinge tabs. Snap out the door (circuit and springs still holding onto the door. Laid the door on the floor. Popped out the 2 hinge plastic covers. Popped the new ones in. Snapped the door back on the hinges. Put the metal tabs back over the hinge peg. After the door was shown to work. Put the new front seal on the door. Caution: You can put the door seal in the wrong configuration thus the seals sticks out and when you pull the lower dish tray out the seal will come off. Look at you old one to ensure the proper technique installing the splastic strip. Done. Pretty simple if you look at the old stuff before replacing the new.
The parts went in really easy and no more leaky dishwasher.
Installed all parts. Dish washer still leaks. Wasted my time and money.
I removed the old spray arm and supply tube using a pair of pliers. Next I installed the new items in the reverse order. The final step was to align the supply tube with the water outlet in the back of the dishwasher. The bracket that came with the spray arm was east to install and aligned the parts perfectly. All in all a very easy and satisfying repair....
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2016 , Eldis Group Partnership. All rights reserved.