Quick Question!

Have you ever purchased from PartSelect.com before?

http://www.partselect.com/Schematics/Whirlpool/6L9DWMHG.gif
See part 2 in the diagram
http://www.partselect.com/Schematics/Whirlpool/6L9DWMHG.gif

Drive Belt

PartSelect Number PS354407

This belt has small cog-tooth, wide spacing and the width is 1/2".

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

Compare At

$51.04

You Save

$8.51

Your Price

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.6 / 5.0, 2 reviews What's this?
1-2 of 2
 

2 of 3 people found this instruction helpful

Parts Used:
Level of Difficulty: Easy
Time to do repair: 15 - 30 mins
Tools: Screw drivers, Socket set
Customer: Luke from Port Clinton, PA

Transmission drive belt broken

Since the belt broke, I had to put the cogged belt on the large driven pulley first, after loosening the four motor mount screws, and sliding the motor as close to the driven belt as I could. After several tries, I positioned the belt successfully on the driven pulley, then slipped it over the pulley on the motor. I pulled the motor as far away from the driven pulley to put proper tension on the belt without being excessive. I snugged the four motor mount bolts, tested the compactor and after a successful run, tightened the bolts on the motor mount. I then replaced the latch assembly, two screws and it was done.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

2 of 5 people found this instruction helpful

Parts Used:
  • Drive Belt
Level of Difficulty: A Bit Difficult
Time to do repair: 15 - 30 mins
Tools: Screw drivers, Socket set
Customer: steven from shebogan, WI

Broken drive belt on the ram

I Removed The Back Panel To Get At The Top Panel Which In Turn I Got To Top Plate To Access The Gear Drive, The Ram Was In The Down Position So I Used a Socket And Rachet To Crank The Ram Up By Hand, I Then Loosened The Plastic Gear Mount To Move The Gear Forward To Attach The New Belt, Then Reversed The Procedure putting The Campactor In operating Condition And It Work's Great

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1-2 of 2