Dishwasher Water Inlet Guide Assembly 4975DD1001A

Hi Kevin, Thank you for your question. The axle that allows the roller to clip onto the dishrack is sold with the roller. The part number for the roller with axle is PS3523050. I hope this helps. Thank you and have a great day!

Hi Florence, thank you for your question. We unfortunately do not have a video for installation. Here are some instructions that may help: You will want to remove the upper and lower dishracks. Close your door after. You will have to uninstall your dishwasher. Make sure to shut off the water and the power to the appliance. Remove the lower access panel and sound dampening pad. Disconnect the water supply line from the water inlet valve. There will be water, so you may want to have a towel handy. Remove the junction box cover and make sure to mark the location of the wires or take a photo so you will remember for later. Detach the strain relief next. Then disconnect the drain hose from the pipe so you can push it through the hole in the cabinet. You will have to pull out the dishwasher but be careful not to damage it. Then open up your door and on the bottom left side, remove the inlet cover. You can do this by sticking something in one of the openings, something like pliers, and twisting the part out of place. Close the door again. Get a towel and tip the dishwasher backward gently. Then use pliers to release the clamps on the tube connected to your guide. Then remove your water tube. Slide the switch cover up and out, then disconnect the wires from the guide. You will then have to look at the bottom of your dishwasher, remove the screws holding in the access plate. After removing that plate you will have access to disconnect the wiring for the sensor, and disconnect the fill, drain, and air hoses from the appliance. Once you have done that you can pull out the old water inlet guide. Follow these steps backwards to reinstall the part. I hope that helps. Good luck with your repair.