351743-1-S-Whirlpool-3976574           -Timer
351743-1-S-Whirlpool-3976574           -Timer 351743-2-S-Whirlpool-3976574           -Timer 351743-3-S-Whirlpool-3976574           -Timer

Timer

PartSelect Number PS351743

This dryer timer is used to control the unit's cycles by regulating the length of time that power is directed to each setting.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

This part fixes the following symptoms:

  • Will Not Start.
  • Timer will not advance.
  • Compare At

    $128.48
  • You Save

    $21.41
  • Your Price

    $107.07
In Stock
Order within the next 4 hrs and your part ships today!
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.1 / 5.0, 2 reviews What's this?
1-2 of 2
 

6 of 8 people found this instruction helpful

Parts Used

  • Timer

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsNutdriver, Pliers, Screw drivers

CustomerVincent from Pipersville PA

Timer not working on all settings

unplug dryer
remove two corner screws on dryer control unit
pull control unit toward you to dislodge and flip over
remove back cover panel
pull off timer knob on front of control unit
unscrew timer from control unit- note orientation of timer so you can replace new timer correctly
holding new timer next to old timer in same orientation
one by one, remover each wire using needle nose pliers and install each wire on new timer in corresponding location.
DO NOT remove all wires at once
Once all wires are relocated on new timer, position timer on control unit and screw back in
Replace cover panel and slide control unit back into place
re-install two corner screws to hold control unit on dryer
re-install old knob on to timer (note flat side on timer shaft should align with flat side of knob hole)
Plug in dryer and test timer
Tell everyone in the house how much you saved by repairing the dryer yourself

Help other customers find the most helpful instructions.

Were these instructions helpful?

5 of 8 people found this instruction helpful

Parts Used

  • Timer

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsPliers, Screw drivers, Wrench set

CustomerThomas from Charlotte NC

Timer was shutting dryer off randomly

I removed the 5 screws holding the back panel behind the timer. I removed the screws that secured the timer to the front panel. I removed the wires to the old timer and placed them on the new timer one at a time. I screwed the new timer onto the front panel and replaced the back panel.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-2 of 2