Timer - 60 Hz

PartSelect Number PS351060

To release knob - pull the tab on the backside of the timer.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

This part fixes the following symptoms:

  • Timer will not advance.
  • Compare At

    $185.86
  • You Save

    $30.98
  • Your Price

    $154.88
In Stock
Order within the next 9 hrs and your part ships today!
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.8 / 5.0, 2 reviews What's this?
1-2 of 2
 

10 of 12 people found this instruction helpful

Parts Used

  • Timer - 60 Hz

Level of DifficultyEasy

Time to do repair:Less than 15 mins

ToolsScrew drivers

CustomerMichael from Choctaw OK

Washer quit during cycle and would not spin

I determined that the timer was defective and needed to be replaced. The repair went fast once I determined how the control panel worked, as the two screws are on the front of this model and not the back. After removing the 2 screws fold up the panel. Make sure you have the machine unplugged from the wall. Unplug the timer, there is a tab on the bottom that locks it in place. Then pull down the small black pin in the center of the main dial, this allows you to pull off the front knob. Next remove the screw under the control knob and the timing unit can be slid over and removed from the panel. The new unit is installed in reverse of the removal. Plug in the control cable and make sure you have the control knob pushed down all the way when you push in the black pin that holds the knob in place (underside of the timing unit). Reinstall the front screws and you’re done.

Help other customers find the most helpful instructions.

Were these instructions helpful?

2 of 5 people found this instruction helpful

Parts Used

  • Timer - 60 Hz

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsNutdriver, Screw drivers

CustomerGERALD from SCOTIA NY

Washer would stop on normal setting after the wash cycle

lid switch checked good.replaced timer assembly.problem repaired.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-2 of 2