Washer Timer

PartSelect Number PS350342

The timer controls most of the operations of the washer: water level, tub filling and emptying, length of cycles, and cycle setting sequences.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

This part fixes the following symptoms:

  • Timer will not advance.
  • Compare At

    $142.78
  • You Save

    $23.80
  • Your Price

    $118.98
In Stock
Order within the next 5 mins and your part ships today!
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.8 / 5.0, 2 reviews What's this?
1-2 of 2
 

14 of 19 people found this instruction helpful

Parts Used

  • Washer Timer

Level of DifficultyA Bit Difficult

Time to do repair:30 - 60 mins

ToolsNutdriver, Screw drivers

CustomerMichael from Coeur d'Alene ID

Washer stops on 1st spin/drain cycle

Unscrew timer/main control knob, then remove 2 spacers behind the knob. Remove 2 main control panel screws at each front lower corner. Rock panel back (pull slightly forward before rocking back to release plastic notches) to expose wire harness and timer. Remove 2 screws holding timer and disconnect timer electrical connector. Put new timer on with screws and attach connector correctly. Rock panel forward into place and reattach panel screws, spacers and knob. Note: Make sure lid switch is working properly before assuming the timer is bad. My switch is also intermittent and needed a shim on lid male plastic piece to engage the switch plate.

Help other customers find the most helpful instructions.

Were these instructions helpful?

7 of 13 people found this instruction helpful

Parts Used

  • Washer Timer

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsScrew drivers

Customercarl from erie PA

Timer stopped moving. Wouldn't change cycles

remove control panel on top back by removing two screws on base. remove two screws in back and lift off control panel. unplug wires from timer. pull knob off shaft and remove two screws under it. timer comes out. reassemble making sure to put knob on with flat spot on shaft and knob in correct position so cycle is displayed properly. real easy job.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-2 of 2